Harman-Kardon AVR 147 owner manual Speaker Placement

Page 19

SPEAKER PLACEMENT

Before you begin to connect cables, it is important to place your speak- ers in their correct locations in the room.

Optimally, the speakers should be placed in a circle with the listening position at its center. The distance from the listening position to the video display forms the radius of the circle. See Figure 15.

The speakers should be angled so that they directly face the listening position.

The center speaker is placed either on top of, below or mounted on the wall above or below the video display screen.

The front left and right speakers are placed along the circle, about 30 degrees from the center speaker and angled toward the listener.

It is best to place the front left/right and center speakers as close to the same height as possible, preferably at about the same height as the listener’s ears. In any event the center speaker should be no more than two feet above or below the left/right speakers.

The side surround speakers should be placed 110 degrees from the center speaker; that is, slightly behind and angled toward the listener. If this isn’t feasible, place them behind the listener, with each surround speaker facing the opposite-side front speaker. The surround speakers may be placed a little higher than the listener’s ears.

The subwoofer’s location is less critical, since low-frequency sounds are omnidirectional. Placing the subwoofer close to a wall or in a corner will reinforce the low frequencies, and may create a “boomy” sound. You may wish to experiment over time by placing the subwoofer where the listener normally sits and then walking around the room until the low frequencies sound best. Place the subwoofer in that spot.

NOTE: Your receiver will sound its best when the same model loudspeaker is used for all positions (other than the subwoofer). If that isn’t possible, try to use speakers made by the same manufacturer.

Video Display

 

Subwoofer

 

Center

Front Left

Front Right

Speaker

Speaker

30°

30°

110°

110°

 

150°

150°

Surround

Surround

Left

Right

Speaker

Speaker

Alternate Placement

Alternate Placement

for Surround

for Surround

Left Speaker

Right Speaker

Figure 15 –

Speaker Placement

19

Image 19
Contents AVR Safety Information Important Safety Information Safety InformationStaple Invoice Here Table of Contents Surround Modes IntroductionThank you for choosing Harman Kardon Audio SectionDigital Audio Inputs Supplied AccessoriesAudio Inputs Audio/Video Inputs With S-VideoFRONT-PANEL Controls Navigation Adjust Input Indicators REAR-PANEL Connections DVD A/V Video 3 Controls televisions and other video displays Remote Control FunctionsChannel Input Selector Press this button to select AVR Selector Power OnRemote Control Functions Multichannel Audio Introduction to Home TheaterSurround Modes Typical Home Theater SystemSpeaker Connections Connecting Source Devices to the AVRConnections Types of ConnectionsAnalog Audio Audio ConnectionsDigital Audio Video ConnectionsRS-232 Serial Port FM antenna uses a 75-ohm F-connector. See FigureAntennas Analog VideoSpeaker Placement Step Three Connect the Antennas InstallationStep One Connect the Speakers Step Two Connect the SubwooferVCR, DVR, PVR Video 1 SourceVideo 3 Source Video 2 SourceHdmi 1 Source No video connections are needed Step Five Connect the Video DisplayHdmi 2 Source TapeStep Seven Insert Batteries in Remote Step Six Plug in AC PowerEnter a code from above Turn on your source deviceTwo steps are required the first time you turn on the AVR Step Nine Turn On the AVRAfter your desired setting appears Initial SetupUsing the On-Screen Menu System Configure the AVR 147 Using EzSet/EQPlug EzSet/EQ microphone into receiver EzSet/EQ Specifying a 7.1 System What EzSet/EQ DoesEzSet/EQ Completed Configure Sources› Button selects the sources in the reverse order Tuner at this timeAudio input assigned to the source You are now ready to begin enjoying your new receiver DMP Setting Menu ScreenTurning On the AVR Sleep TimerVolume Control OperationSource Selection HeadphonesMute Function Tone ControlsWe recommend that you connect this player as follows Audio Input SelectionVideo Input Selection Channel Direct InputsChannel Input Selector Using the TunerRecording XM Radio OperationTuning Down Using TheBridgeTMSelect a Surround Mode Remote Selecting a Surround ModeAudio Processing and Surround Sound Analog Audio SignalsDigital Audio Signals Advanced FunctionsDolby Surround Settings Passages to avoid disturbing others Default Modes0 or Dolby Digital EX played asDolby Digital 2.0 or Surround Mode Description Incoming Bitstream or SignalPanorama adjusts wraparound surround effect See belowAre available Logic Step One Determine Speaker Size Manual SetupStep Three Manual Setup Menu Step Two Measure Speaker DistancesSpeaker Size Menu Large settingSpeaker Crossover Menu Delay Adjust MenuMake sure all speakers have been connected correctly Step Four Setting Channel Output Levels ManuallyUsing the Remote Control With the Test Tone Using the Front-Panel or Remote Control Channel CommandUsing the Full-OSD Menu System SettingsTo dim the display Advanced Remote Control FunctionsDim Function Punch-Through ProgrammingTo program, or record a macro, follow these steps Resetting the RemoteProcessor Reset Troubleshooting Guide DTS AVR 147 Technical SpecificationsTable A3 Delay Setting Defaults Appendix Default settings, worksheets, remote product codesTable A1 Source Input Setting Defaults Table A2 Speaker/Channel Setting DefaultsTable A5 Speaker/Channel Setting Table A4 Source Input SettingTable A7 System Settings Table A6 Remote Control CodesRemote Control Function List Reference TV VID3 Remote Control Function ListFAV Aiwa Table A10 Table A9Table A12 Remote Control Product Codes DVD Table A11 Remote Control Product Codes CDTable A14 Remote Control Product Codes Tape Table A13 Remote Control Product Codes SATTable A15 Remote Control Product Codes CBL Table A15 Table A16 Remote Control Product CodesPage
Related manuals
Manual 52 pages 60.25 Kb Manual 2 pages 42.45 Kb

AVR 147 specifications

The Harman-Kardon AVR 147 is an entry-level receiver designed for those who seek quality audio and video experiences without overcomplicating their setup. This model is part of Harman-Kardon's well-known line of audio-video receivers, designed to provide an immersive home theater experience.

At the heart of the AVR 147 is its 5.1 channel surround sound capability, allowing for the connection of up to five speakers plus a subwoofer. This configuration enables a rich sound field that envelops listeners, ideal for both movies and music. The receiver can deliver up to 40 watts per channel, providing sufficient power for a modest home theater setup. The incorporation of Dolby Digital and DTS decoding ensures that users can enjoy their favorite movies with cinematic sound quality.

One of the main features of the AVR 147 is its user-friendly interface. The simplified remote control and intuitive on-screen menu make it easy for users to navigate settings and optimize sound performance. The receiver also offers multiple inputs, including HDMI, component, composite, and optical connections, ensuring compatibility with a wide range of audio and video sources, such as Blu-ray players, gaming consoles, and streaming devices.

The AVR 147 is equipped with Harman Kardon’s proprietary technologies, including the Advanced DSP (Digital Signal Processing), which enhances audio quality and clarity. Moreover, it supports various surround sound formats, allowing users to enjoy an enhanced home theater experience tailored to their preferences.

Another noteworthy characteristic is its sleek, modern design, which blends seamlessly into any entertainment setup. With its front panel display, users can easily see their settings and selections. The robust build quality of the AVR 147 ensures durability and longevity, making it a wise investment for those passionate about audio-visual technology.

In terms of video accessories, the AVR 147 can upscale standard-resolution video sources to provide a better viewing experience. Although it lacks some of the advanced features found in higher-end models, the AVR 147 remains a commendable choice for anyone seeking an effective and powerful home theater solution without excessive complexity. Whether you're watching movies, playing video games, or enjoying your favorite music, the Harman-Kardon AVR 147 is a reliable companion in elevating home entertainment experiences.