Brother XL-2600 operation manual Important Safety Instructions

Page 2

IMPORTANT SAFETY INSTRUCTIONS

When using this machine, basic safety precautions should always be taken, including the following:

Read all instructions before using.

DANGER - To reduce the risk of electric shock:

1.The machine should never be left unattended while plugged in. Always unplug the machine from the electrical outlet immediately after using and before cleaning.

2.Always unplug the machine before you change the light bulb. Replace the bulb with same type rated 15 watts.

WARNING - To reduce the risk of burns, fire, electric shock, or injury to persons:

1.Do not allow this machine to be used as a toy. Close attention is necessary when the machine is used by or near children.

2.Use this machine only for its intended use as described in this manual. Use only accessories recommended by the manufacturer as contained in this manual.

3.Never operate this machine if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the machine to the nearest authorized dealer or service center for examination, repair, electrical or mechanical adjustment.

4.Never operate the machine with any air openings blocked. Keep ventilation openings of the machine and foot control free from the accumulation of lint, dust, and loose cloth.

5.Never drop or insert any object into any opening.

6.Do not use outdoors.

7.Do not operate where aerosol (spray) products are being used or where oxygen is being administered.

8.To disconnect, turn the machine switch to the symbol “{” position which represents off, then remove plug from outlet.

9.Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

10.Keep fingers away from all moving parts. Special care is required around the machine needle.

11.Always use the proper needle plate. The wrong plate can cause the needle to break.

12.Do not use bent needles.

13.Do not pull or push fabric while stitching. It may deflect the needle, causing it to break.

14.Switch the machine to the symbol “{” position to turn it off when making any adjustments in the needle area, such as threading needle, changing needle, threading bobbin, or changing presser foot, and the like.

15.Always unplug the machine from the electrical outlet when removing covers, lubricating, or when making any other user servicing adjustments mentioned in the instruction manual.

16.This sewing machine is not intended for use by young children or infirm persons without supervision. (For Australia and New Zealand only)

17.Young children should be supervised to ensure that they do not play with this machine.

SAVE THESE INSTRUCTIONS

This machine is intended for household use.

1

Image 2 Contents
Manual de Instrucciones Important Safety Instructions Instrucciones Importantes DE Seguridad For Users in the UK, EIRE, Malta and Cyprus only Please Read These Instructions Before YOU USE the Machine LEA Estas Instrucciones Antes DE Utilizar LA Máquina Contents Appendix Contenido USO DE Accesorios Y Aplicaciones Knowing Your Sewing Machine Main PartsConozca SU Máquina DE Coser Accessories / Accesorios Part Name Part CodeOptional Accessories / Accesorios opcionales Part Name Part Code OthersUsing Your Sewing Machine USO DE LA Máquina DE Coser Machine must be unplugged. For U.S.A. only Connecting Plugs Conexión de enchufesFoot Controller / Pedal Sólo para EE.UUChecking the Needle Comprobación de la aguja Replacing the Needle Cambio de la agujaPresser foot lever / Palanca del pie prensatela Changing the Presser Foot Cambio del pie prensatela Slide the flat bed attachment to the left to release it Using a Free-arm Style Uso del estilo de brazo libreFlat Bed Attachment Unidad de cama plana Controls / Controles Pattern Selection Dial Selector de puntadasPosition / Cambio Stitches / 25 puntadas3/16 64-1/16 16-3/16 De posición de la Aguja3/16 Fixed / Fija Fixed / FijaFixed / Fija Aguja 3/32 13/64 3/32 3/16 3/32Selecting a Stretch Stitch Stitch Length Dial Control de longitud de puntadaStretch Stitching Costura elástica Stitch Width Dial Control de anchura de puntada Reverse Sewing Lever Pulsador de retrocesoThreading the Machine / Enhebrado DE LA Máquina Winding the Bobbin / Devanado de la bobinaPage Lower Threading Enhebrado del hilo inferior Cover / Tapa Slide button / Deslizador Cover as shown by the line This feature is only available on certain modelsReplace the cover so that the end IllustrationThread unrolls in the wrong direction Used with this machineEsta máquina Upper Threading / Enhebrado del hilo superior Suba el pie prensatela con la palanca del pie prensatela4Feed the upper thread as previously shown Putneedle.the thread behind the guide aboveApague la máquina y baje la palanca del pie prensatela Page 3Replace the bobbin cover Sewing with a Twin Needle Costura con aguja gemelaQuick-set Bobbin Threading Vuelva a colocar la tapa de la bobina2Thread the right needle Twin Needle ThreadingUse only twin needles that have been made for Attaching the Twin NeedleUpper Tension is too Loose Solution / SoluciónThread Tension Tensión del hilo Upper Tension is too TightMedium FabricsMemo/Recuerde 16-0 Straight Stitching / Costura rectaPuntada recta 64-3/16 Thread could tangle or the needle could Make sure the needle does not hit a pinOr any other object during sewing. Changing Sewing DirectionPara preparar la máquina para la siguiente Zigzag Stitching Costura en zig-zagMachine Top Stitching and Stretch MaterialsStraight and Zigzag Stitching / Costura Recta Y EN ZIG-ZAG Cosa en el pliegue como se indica en la figura C Blind Hem Stitching Costura invisible para dobladilloSew on the fold as in Fig. C Elastic Stitching Costura elástica Adjust the thread tension so that it is tighter than normalShell Tuck Stitching Costura de concha Sew at a slow speedDouble Action Stitching Costura de doble acción Sewing Elastic / Costura de gomasPuntada de Heirloom Stitching Puntada de adornosOveredge Stitching Costura de sobreorilla 3/16Ajuste el selector de puntadas en la puntada de sobreorilla Feather Stitching Costura de plumas1Setstitch.the pattern selection dial to an overedge Decorative Stitching Costura decorativa PuntadaPage Lowerslightly.the buttonhole lever and push it back Baje la palanca para ojales y empújela hacia atrás un pocoLas tachuelas del ojal se cosen en el orden que se muestra Pare la máquina cuando termine de coser el ojal+ direction Adjusting Buttonholes Ajuste de ojalesDirection Destornillador grande en la direcciónSewing Buttons Costura de botones 2Turn off the machineRecta Zipper Insertion Costura de cremallerasCentro Turnfoot. off the machine and raise the presserSewstitches.a single row or many rows of straight Gathering / FruncidosSetStitch.the pattern selection dial to Straight 4Pull the lower threads to gather the materialPie Placa Puntada Cualquiera Darning / ZurcidosAppliqués / Aplicaciones 2Set the pattern selection dial to Zigzag Stitch 3Cutstitching.away any fabric that is left outsideBe careful that the needle does not hit a Keep fingers away from moving parts, especially needles Cosa el contorno del diseño moviendo el aro de bordado Asegure con unas cuantas puntadas rectas al final del diseñoTurn off the machine Optional Accessories / Accesorios OpcionalesUsing the Walking Foot Utilización del pie móvil 2Raise the needle and the presser foot Using the Quilting Foot Utilización del pie para acolchados1Turn off the machine Levante la aguja y el pie prensatela6SetStitch.the pattern selection dial to the Straight Attach the 1/4-inch Quilting Foot. Turn on the machine Using the 1/4-inch Quilting FootUtilización del pie para acolchados de 1/4 pulgadas Stitching the Top of a QuiltDespués de coser entre 2 3/4 pulg. y 3 cm Any Puntada Cualquiera Recta Attach the Blind Stitch Foot. Turn on the machineSetStitch.the pattern selection dial to the Zigzag When Sewing Seams / Para coser costurasWhen Blind Hem Stitching Ajuste el selector de puntadas en la puntada de zig-zagMaintenance / Mantenimiento Changing the Light Bulb Cambio de la bombillaCoja la caja de la bobina y tire de ella hacia la izquierda Cleaning / LimpiezaGraspthe left.the bobbin case, and then lift it out to Do not apply oil to the bobbin caseInstall the needle plate cover Troubleshooting Thread ten LowerOr breaks Fabric isThere is a high Stitches areSkipped Pitched noise While sewingSolución de problemas Devane el hilo de la bobina Elija la aguja adecuada para el tipoEl hilo superior Que está utilizando De costura Se rompe Caja de la bobina Está enredado o Se rompeRetire la cubierta de la placa de la Correctamente SuperiorCorrectamente No ha enhebrado el hilo superior Placa de la aguja o en la caja de laCostura no se Enciende Está enganchado en la caja de la Bobina, limpie la cajaSustituya la bombilla de costura Index NumericsÍndice ENGLISH/SPANISH