Kenmore 625.38306 owner manual Bypass Valves, Model no .383060 Timer Code S

1

\

/

BYPASS VALVES

Bypass valve(s) should always remain in soft water service position. Position in "bypass" only if needed for softener repairs.

! SINGLE BYPASS

pull stem

outward for

service

,t_-- B --_

A

push inward for bypass

,\/

\J

				Inches		cm	3 VALVE	BYPASS
							FOR SERVICE
A	Salt Tank	Height		40-1/4		102.2	close bypass valve
B	Resin Tank Diameter			8		20.3	open inlet & outlet valves
	(nominal)						FOR BYPASS		Outlet
C	Resin Tank Height (nominal)			40		101.6	open	bypass	valve
							close inlet & outlet
D	Inlet-Outlet	Height		41-1/2		105.4
E	Overall Height			47-3/4		121.3
I=1	Length			19-3/4		50.2
1=2 Width				16-1/2		41.9
-	Distance between inlet-outlet			3-3/8		8.6
	centerlines
			MODEL NO. 625.383060 - TIMER CODE S 25
		WATER SUPPLY TO WATER SOFTENER
		Minimum water system flow (gpm)							3
		Minimum-maximum		water	pressure	(psi)		20 - 125
		Minimum-maximum		water	temperature (°F)			40 - 120
		Maximum	water hardness		(gpg)				95
		Maximum	"clear water" iron (ppm)*						7
		SALT FOR WATER		SOFTENER
		Type of salt needed						nugget	or pellet
		Alternate	type of salt					pure, evaporated, compacted
								water softener salt

gpm = gallons per minute gpg = grains per gallon

psi = pounds per square inch ppm = parts per million

*Capacity to remove clear water iron is substantiated by WQA test data. State of Wisconsin requires additional treatment if water supply contains greater than 5 ppm clear water iron.

Bypass valve

Inlet valve

FIG. 44

Questions? Call The Kenmore Water Line 1-800-426-9345

32