Mitsubishi Electronics MSZ-GA24NA Installation Place and Electrical Work, Specifications

Page 11

WHEN THE AIR CONDITIONER IS NOT GOING TO BE USED FOR A LONG TIME

1 Set to the highest temperature in manual COOL mode, and operate for 3 to 4 hours. Page 5

This dries the inside of the unit.

Moisture in the air conditioner contributes to favorable conditions for growth of fungi, such as mold.

2

Press

to stop the operation.

3

Turn off the breaker and/or disconnect the power sup-

 

ply plug.

 

INSTALLATION PLACE AND ELECTRICAL WORK

Installation place

Avoid installing the air conditioner in the following places.

Where there is much machine oil.

Salty places such as the seaside.

Where sulfi de gas is generated such as a hot spring.

Where oil is splashed or where the area is fi lled with oily smoke.

Where there is high-frequency or wireless equipment.

Where the air from the outdoor unit air outlet is blocked.

Where the operation sound or air from the outdoor unit does not bother the house next door.

The installation location of the outdoor unit should be at least 10ft (3 m) away from the antennas for TV sets, radios, etc. In areas where the reception is weak, provide greater space between the outdoor unit and the antenna of the affected device if operation of the air conditioner interferes with radio or TV reception.

4 Remove all batteries from the remote controller.

When using the air conditioner again:

1

Clean the air fi lters.

 

 

Page 8

 

 

 

 

2

 

 

 

To prevent the effects of a fl uorescent lamp, keep as far apart as possible.

3ft

(1m)

or more

3 ft (1m)

 

or more

Cordless phone or Portable

Inverter-type

fl uorescent lamp

Keep a space to prevent the pic- ture distortion or the noise.

TV

wall, etc.

Well- ventilated dry place

4 in (100 mm)

or more 20 in

(500 mm) or more

Check that the air inlet and outlet of the indoor and

outdoor units are not blocked.

phone

Radio

10 ft (3 m) or more

3 Check that the ground wire is connected correctly.

SPECIFICATIONS

Guaranteed operating range

 

 

Indoor

Outdoor

 

Upper limit

90°F (32.2°C) DB

115°F (46.1°C) DB

Cooling

73°F (22.8°C) WB

Lower limit

67°F (19.4°C) DB

14°F (-10°C) DB

 

 

57°F (13.9°C) WB

 

 

 

Upper limit

80°F (26.7°C) DB

75°F (23.9°C) DB

 

65°F (18.3°C) WB

 

 

Heating

Lower limit

70°F (21.1°C) DB

5°F (-15°C) DB

(USA model)

4°F (-15.6°C) WB

 

Lower limit

70°F (21.1°C) DB

14°F (-10°C) DB

 

(Canada model)

13°F (-10.6°C) WB

 

 

 

DB : Dry Bulb

 

 

 

WB : Wet Bulb

Electrical work

Provide an exclusive circuit for the power supply of the air conditioner.

Be sure to observe the breaker capacity.

If you have any questions, consult your dealer.

En-10

Image 11
Contents For user SPLIT-TYPE AIR ConditionersContents Provide a dedicated power supply for the air conditioner Do not pull the power cordDo not operate switches with wet hands Consult your dealer for installing the air conditionerOutdoor unit Remote controllerName of Each Part Indoor unitPreparation Before Operation Installing the remote controller batteriesSetting current time Changing temperature units ºF→ºCSelecting Operation Modes Swing FAN Speed and Airflow Direction AdjustmentAuto ManualEcono Cool Operation Powerful OperationWhat is Econo COOL? Air filter Catechin air filter CleaningAir cleaning filter Anti-Allergy Enzyme Filter Front panelWhen YOU Think That Trouble has Occurred When using the air conditioner again Installation Place and Electrical WorkSpecifications Installation placeSímbolos utilizados en este manual y su significado ÍndiceMedidas DE Seguridad Indicaciones y sus significadosPida a su distribuidor que instale el aire acondicionado No tire del cable de alimentaciónNo cargue ni desarme las pilas y no las arroje al fuego No utilice los mandos con las manos mojadasControlador remoto Nombre DE LAS PartesUnidad interior Unidad exteriorCambio de unidades de temperatura ºF→ºC Preparación Antes DE LA Puesta EN MarchaInstalación de las pilas del controlador remoto Ajuste de la hora actualSelección DE Modos DE Funcionamiento Orden siguiente OscilaciónPulse Dirección del aire cambia con cada pulsación en elFuncionamiento Powerful Potente Instrucciones LimpiezaFiltro de aire filtro de aire de taninos Parte posterior del filtro de aireSI Cree QUE HA Ocurrido Algún Problema Lugar de instalación EspecificacionesLugar DE Instalación Y Trabajo Eléctrico Al volver a usar el acondicionador de aireTable DES Matieres Symboles et leur significationSignification des symboles utilisés dans ce manuel PrecautionPrévoir un circuit réservé à l’alimentation du climatiseur Ne jamais tirer sur le cordon d’alimentationNe pas faire fonctionner le climatiseur pendant plus de Couper le disjoncteur par temps d’orageUnité externe PowerfNomenclature Unité interneChangement des unités de température ºF→ºC Insertion des piles dans la télécommandePreparatif D’UTILISATION Réglage de l’heureSelection DES Modes DE Fonctionnement ’ailette monte et descend de façon intermittente ManuelOscillation AutoClignote Appuyez sur les touches Augmenter etDiminuer pour régler l’heure de la minuterie PuissanceFiltre à air filtre à air catéchine NettoyagePanneau frontal Filtre d’épuration d’air filtre antiallergique à enzymesEN Presence D’UNE Panne Potentielle Fiche Technique Lieu D’INSTALLATION ET Travaux ElectriquesLorsque le climatiseur doit être remis en service Lieu d’installationJG79A166H01

MSZ-GA24NA specifications

The Mitsubishi Electronics MSZ-GA24NA is a versatile and efficient ductless mini-split air conditioning unit that has garnered attention for its advanced features and reliable performance. Designed for residential and light commercial applications, this model combines energy efficiency with innovative technology to deliver optimal indoor comfort year-round.

One of the standout features of the MSZ-GA24NA is its impressive Seasonal Energy Efficiency Ratio (SEER) rating, which ensures lower energy consumption while delivering powerful cooling and heating capabilities. This unit is equipped with a high-efficiency inverter-driven compressor, enabling it to adjust its capacity based on current temperature needs. This results in stable cooling and heating, along with significant energy savings over time.

The MSZ-GA24NA employs advanced filtration systems, including a high-efficiency HEPA filter, which captures even the smallest particles, improving indoor air quality. Additionally, it features a built-in plasma filter that neutralizes odors and eliminates harmful pollutants, making it an excellent choice for allergy sufferers and those seeking cleaner air.

This model is equipped with Mitsubishi's proprietary i-See Sensor technology. This innovative feature allows the unit to detect the temperature distribution within the room, adjusting air direction accordingly for uniform comfort. The i-See Sensor ensures that the space maintains a consistent temperature, preventing hot or cold spots, which enhances overall comfort for occupants.

Noise reduction is another crucial characteristic of the MSZ-GA24NA. Designed with a quiet operation mode, the indoor unit operates at a sound level as low as 19 dB, making it one of the quietest systems in its class. This makes it ideal for bedrooms, offices, or any space where noise may be a concern.

The MSZ-GA24NA also offers user-friendly controls, with options for wireless remote control and compatibility with smart home systems. This allows users to easily adjust settings, monitor energy consumption, and create schedules to optimize comfort and efficiency.

Durability and reliability are key aspects of the MSZ-GA24NA, which is engineered to withstand various weather conditions, thanks to its robust construction and weather-resistant components. Its slim design enables easy installation in a variety of spaces, making it a versatile choice for many applications.

In summary, the Mitsubishi Electronics MSZ-GA24NA stands out in the market for its blend of efficiency, advanced technology, and user-friendly features. With exceptional cooling and heating capabilities, air quality enhancements, and a commitment to silent operation, it is an ideal solution for those looking to improve their indoor environment while keeping energy costs low.