Mitsubishi Electronics MSZ-FA25VA, MSZ-FA35VA Check of remote controller and receiver P.C. board

Page 22

Indoor unit operates by pressing EMERGENCY OPERATION switch, but does not operate with the remote controller.

B Check of remote controller and receiver P.C. board

wCheck if the remote controller is exclusive for this air conditioner.

Switch on the remote controller.

Is LCD display on the the remote

No

 

controller visible?

 

(not clear)

Yes

Replace the batteries. (Refer to 9-1.4.)

Remove the batteries, then set them back and press RESET button. (Refer to 9-1.4.) Check if the unit operates with the remote controller.

Does the unit operate with the

No

 

remote controller?

 

Yes

 

OK

 

Turn on a radio to AM and press switch on the remote controller.

Is noise heard from radio?

 

No

 

 

 

 

Yes

 

 

 

 

 

 

 

 

Are there any fluorescent lights of

Yes

inverter or rapid-start type within

 

 

 

 

the range of 1m?

 

 

Replace the remote controller.

Reinstall the unit away from lights.

Attach a filter on receiving part.

Replace the indoor electronic control P.C. board.

22

Image 22
Contents Contents MSZ-FA25VA E1 MSZ-FA35VA E1Generalized stepping motor Technical ChangesFront panel opening/closing output gear Indoor Unit MSZ-FA25VA MSZ-FA35VA Wash reset switch Open Closed Receiving sectionPart Names and Functions See control operationMSZ-FA25VA E1 MSZ-FA35VA E1 Accessories Remote ControllerSpecifications and rating conditions of main electric parts SpecificationWhen outdoor unit is MXZ type MSZ-FA25VA E1 Noise Criteria CurvesMSZ-FA35VA E1 Indoor Unit Outlines and DimensionsMSZ-FA25VA E1 MSZ-FA35VA E1 Unit mmMSZ-FA25VA E1 Indoor Unit Wiring DiagramRefrigerant System Diagram MSZ-FA35VA E1 Indoor UnitRemote controller model KM05A Service FunctionsHow to modify the remote controller P.C. board OperationRemote controller Troubleshooting Install RemoveInformation for Multi System AIR Conditioner Outdoor Unit MXZ seriesFailure mode recall function OFFTo identify the error.Refer to 9-6.For G Plasma AIR Purifying Indoor unit failure mode tablePlasma Deodorizing OFFInstruction of troubleshooting StartTroubleshooting check table · Flashing of Power lamp indicates abnormalitiesAIR PlasmaPurifying Trouble criterion of main parts When Power lamp flashes 3-time Indoor fan does not operate Troubleshooting flowCheck of indoor fan motor Check of remote controller and receiver P.C. board Indoor electronic control P.C.Board How to check mis-wiring and serial signal error LEDCheck of installation of the horizontal vane Safety Deviceplasma Unit Plasma Deodorizing 0V?Continuously flash? AIR Purifying 0V?Check of auto front panel Indoor unit and outdoor unit do not operateElectromagnetic noise enters into TV sets or radios YesPlasma power P.C. board Test point diagram and voltagePower monitor receiver P.C. board Indoor electronic control P.C. boardDisassembly Instructions Removing the panel PhotoOperating Procedure Photos Removing the electrical boxRemoving the indoor fan motor and the line flow Photo Removing the horizontal vane motor unit PhotoRemoving the vertical vane motor unit Photo FanRemoving the plasma power P.C. board Photo Parts List Accessory and Remote ControllerIndoor Unit Heat Exchanger Safety PlasmaIndoor Unit Electrical Parts and Functional Parts Motor Receiver P.C Board Holder509 Symbol Qty/unit Part name WiringDiagram E02 504Optional Parts Deodorizing Ceramic FilterPage Specifications subject to change without notice