Electrolux D4100 Connecting to Mains Terminal, Connecting to a HOB or Cooker Point

CONNECTING TO MAINS TERMINAL

WARNING: This cooker must be

	earthed.
	Make connection as shown in Fig. 7 by
	proceeding as follows:-
	Preform wires to the appropriate shape to suit
	fitting into the mains terminal block.
	Strip inner insulation on wires using
	wirestrippers.
	Twist the bared wires using pliers.
	Cut bared wires 10mm away from the end of	Fig.7
	the inner insulation. Where uninsulated Earth
	wires are used ensure they are suitably
	sheathed to leave 10mm bare wire to fit into
	the terminal.
	Clamp bare wires into the relevant terminal and
	check they are held by tugging each one in turn.
	Clamp the mains cable securely ensuring 5mm
	of the outer insulation is inside the terminal
	block and that the wires are not taut but not so
	slack as to cause any fouling. See Fig. 7.
	Place fuse/miniature circuit breaker in circuit
	and switch on at mains.
CONNECTING TO A HOB OR COOKER
POINT
	Either follow in general terms the instructions
	for connecting to the terminal block or refer to
	the hob suppliers installation instructions.
	Feed the cable through the cabinet and
	arrange to route the cable away from
	the cooker which may become hot.
CHECKING ELECTRICAL
CONNECTIONS
	Correct electrical connection can be confirmed
	when switching on the appliance as the timer
	will be flashing.
NOTE: HOUSE CIRCUIT
Earth leakage and continuity tests must be carried
out before the cooker is connected to the mains
supply and re-checked after fitting.

47