Electrolux R H G 5 0 G Connecting to GAS, Fitting the Battery, Pressure Testing

Page 37

R H G 5 0 G

5.CONNECTING TO GAS

This appliance is designed to be installed with an appliance flexible connection only. Supply piping should not be less than R³/8 (³/8" B.S.P.). Connection is made to the Rc½ (½" B.S.P.) female threaded entry pipe located just below the hotplate level on the rear left hand side of the appliance.

Check for gas soundness after connecting the gas supply.

The gas bayonet connector must be fitted in the shaded area indicated in Fig. 3. Take into account that it must be possible to pull the appliance forward sufficiently. The

hose must not get caught on the stability bracket.

Fig.3

All dimensions in mm

IMPORTANT: FLEXIBLE TUBING USED MUST COMPLY WITH BS. 669 CURRENT EDITION. L.P.G. FLEXIBLE CONNECTIONS MUST BE OF A TYPE SUITABLE FOR L.P.G. AND CAPABLE OF OPERATION UP TO 50MBAR AND TO CARRY A RED STRIPE, BAND OR LABEL.

NOTE: ONLY LIQUID SEALANTS CAN BE USED IN THREADED GAS CONNECTIONS. DO NOT USE P.T.F.E. TAPE.

6.FITTING THE BATTERY

1.The battery holder is located at the front left hand side of the bottom storage compartment (see Fig. 4).

2.Open bottom compartment flap to gain access to the battery holder.

3. From inside the bottom compartment fit the 1.5 voltFig.4 battery (see Fig.4) ensuring it is fitted as indicated by the

symbols on the battery holder.

7.PRESSURE TESTING

1.The oven injector is used as the pressure test point.

Remove the oven furniture. Remove oven burner box retaining clips (one spring clip from each side) and remove box front cover. Replace one clip back into the right hand side of the burner box.

Remove oven burner by removing the spring clip from the right hand side of the oven burner and slide the burner off the injector whilst easing it towards the front of the appliance, taking care not to strain the F.S.D. phial.

2.Connect the pressure gauge to the oven injector.

3.Check the supply pressure by turning the thermostat on and one hotplate tap full on and light the appropriate burner.

The pressure should be either:

(i)

For Natural Gas

20mbar

(ii)

For LP.Gas

The pressure must be set to 28 mbar for use on butane or 37 mbar for use

 

 

on propane.

4.Turn off the taps, disconnect the pressure gauge and replace oven burner and cover, ensuring that the F.S.D. phial is correctly located into the bracket on the burner.

5.Check operation of oven.

8.CHECKING THE GRILL

Fit the grill shelf to the splashplate canopy (4 screws).

Place the grill pan containing the grid on to the grill pan shelf. Light the grill burner by turning the tap to its full

on position and pressing the ignition button. As soon as the burner is lit the button can be released.

If the ignition of the grill fails ensure the grill H.T. wire is fitted to the generator (see Section 2).

37

Page 36 Page 38
Image 37
Page 36 Page 38
Contents G 5 0 G Introduction For your safetyG 5 0 G N t e n t s Grill and hotplate Lighting the cookerOven To lightTo turn off any burner Grill control gives two heat settings Prior to using the grillGrill Heat controlPreheating Cooking positionsPositioning food on the grid Burner sizes HotplateFor your Safety Helpful hints Heat zones OvenOven Shelves If you are cooking more than one trayRoasting Baking trays and dishes For your safetyCondensation Oven cooking chart Mins. per ½ kg 1lb and 15 mins Mins. per ½ kg 1lb and 25 mins10 15 minutes for each ½ kg 1lb ¼-2½ hoursMins Cooking Oven ChartGRolls and buns Mins Food preparation slow cooking Slow cookingJoints of meat and poultry Vegetables G 5 0 G Soups, casseroles and stewsMilk puddings General points for slow cooking Frozen foodsG 5 0 G Reheating Cleaning the brass plated handle Where applicable Care and cleaning For your safetyHotplate Grill When replacing hotplate burner partsOver Follow the oven cleaning cycleOven roof This will prevent fat splashingPresentably clean Oven cleaning cycleGeneral Least 30 minutesTo remove the outer glass Cleaning the glass doorYou can remove the glass from the oven door if you need to Installing the cooker For your safety Cleaning The Door GlassLocation G 5 0 G Positioning Cooker dimensionsOverall height 1457mm 1475mm Height to hotplate 902mm 920mm Width 498mm DepthBattery General information For your safetyMoving your cooker Storage Problem What is wrong and why?Check LCheckG 5 0 G Problem Make a note of this information in this space Service and spare partsName Model Number Serial Number Customer Care Department Installation Instructions Connections DimensionsIgnition GrillProvision for Ventilation Important Safety RequirementsLocation of Appliance Grill AssemblyParts Required Fitting the Stability Bracket Levelling the ApplianceFitting the Battery Connecting to GASPressure Testing Checking the GrillChecking the Main Oven Checking the HotplateGeneral Note Contents Check List Pan Support Electrolux Household Appliances Limited
Top Page Image Contents