Electrolux E15IM60E manual Site Preparation, Preparing the Site

Page 10

Site Preparation 11

PREPARING THE SITE

IMPORTANT

It is extremely important that the unit is level. If it is not level, the ice mold will not fill evenly. This can cause a reduction in ice rate, uneven sized cubes or water spilling into the storage area which will cause the ice in the bin to melt pre-maturely. Remember that floors near drains have a tendency to slope towards the drain.

1Position the unit on a flat, level surface, capable of supporting the entire weight of the unit. Remember that the unit will be significantly heavier once it is fully loaded.

2The surrounding air temperature must be at least 50°F (10°C) but must not exceed 110°F (43°C).

3The unit must not be located near heat-generating equipment or in direct sunlight.

!DANGER

ELECTROCUTION HAZARD!

Electrical Grounding Required. This appliance is equipped with a three prong (grounding) polarized plug for your protection against possible shock hazards.

•NEVER remove the round grounding prong from the plug.

•NEVER use a two-prong grounding adapter.

•NEVER use an extension cord to connect power to the unit.

Where a two-prong wall receptacle is encountered or a longer power cord is required, contact a qualified electrician to have it replaced in accordance with applicable electrical codes.

4The unit must be located to allow clearance for water, drain and electrical connections in the rear of the ice maker.

5Connect the unit to a grounded and polarized 115 VAC, 60 Hz, 15 A circuit (normal household current).

6Avoid connecting the unit to a Ground Fault Interruptor (GFI). GFIs are prone to nuisance tripping which will cause the unit to shut down. GFIs are generally not used on circuits which power equipment that must run unattended for long periods of time.

7The unit must be installed according to your local codes and ordinances.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Use & Care Guide Please Read and Save this Guide Finding InformationMake a Record for Quick Reference Product Registration Card QUESTIONS?Safety Precautions SafetyImportant Safety Instructions DefinitionsGeneral Precautions Installation Installation DimensionsIce Makers With Factory Installed Drain Pump Drain InstallationInstalling the Drain Gravity DrainBack View Connecting a Drain Pump Drain Pump ConnectionSite Preparation Preparing the SiteCabinet Or Wall Door Swing Clearance Needed Connecting the Water Supply Water Supply ConnectionUL134 Leveling Leveling the UnitDoor Reversal Reversing the Door Some ModelsHinge Screw PIN Adjusting the Door DoorAdjustmentTo adjust Door Closers Boss Table of Contents Built-In Installation Installing a BUILT-INStart-up Initial START-UPNormal Operation OperationIce Cube Thickness ICE Dispenser Operation & Care Sample Area Exterior Cleaning As Required MaintenanceMaintaining and Cleaning Your Icemaker Special ConsiderationsInterior Cleaning As Required Do not Clean with Steel Wool PadsCondenser Cleaning Every 3 Months Self Cleaning Every 6 Months Inlet Screen Cleaning Every Year Storage, Vacation and Moving Draining for NON-USEBefore YOU Call for Service TroubleshootingTroubleshooting Guide If Service is Required Problem Possible Cause RemedyWarranty Information Period WE will Responsible for Full ONE-YEAR
Top Page Image Contents