Electrolux E15IM60E manual Drain Installation, Installing the Drain, Gravity Drain

Page 7

8Drain Installation

INSTALLING THE DRAIN

!CAUTION

PLEASE READ all instructions completely before attempting to install or operate the unit. All ice makers require a connection to the water supply and improper hook-up can result in substantial property damage! All water and drain connections MUST BE made by a licensed/qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm.

!CAUTION

Plumbing installation must observe all state and local codes. All water and drain connections MUST BE made by a licensed/qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm.

Model E15IM60E can be installed using a gravity drain or can use a factory installed or equivalent drain pump.

Follow these guidelines when installing drain lines to prevent water from flowing back into the ice maker storage bin and/or potentially flowing onto the floor causing water damage:

Gravity Drain

•Drain lines must have a 5/8 inch inside diameter.

•Drain lines must have a 1 inch drop per 48 inches of run (1/4 inch per foot) and must not create traps.

•The floor drain must be large enough to accommodate drainage from all drains.

•Insulate the bin drain line to prevent condensation.

Ice Makers With Factory Installed Drain Pump

!CAUTION

Before installing an icemaker with a factory installed pump, it is extremely important to check and test all hose connections at the drain pump. There is a possibility that hose connections may have loosened during shipment.

!WARNING

To prevent accidental electrocution, make certain that the floor surfaces surrounding the unit are dry whenever power is removed from, or applied to the unit.

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Use & Care Guide Please Read and Save this Guide Finding InformationMake a Record for Quick Reference QUESTIONS? Product Registration CardDefinitions SafetyImportant Safety Instructions Safety PrecautionsGeneral Precautions Installation Dimensions InstallationGravity Drain Drain InstallationInstalling the Drain Ice Makers With Factory Installed Drain PumpBack View Drain Pump Connection Connecting a Drain PumpPreparing the Site Site PreparationCabinet Or Wall Door Swing Clearance Needed Water Supply Connection Connecting the Water SupplyUL134 Leveling the Unit LevelingReversing the Door Some Models Door ReversalHinge Screw PIN Adjusting the Door DoorAdjustmentTo adjust Door Closers Boss Table of Contents Installing a BUILT-IN Built-In InstallationInitial START-UP Start-upNormal Operation OperationIce Cube Thickness ICE Dispenser Operation & Care Sample Area Special Considerations MaintenanceMaintaining and Cleaning Your Icemaker Exterior Cleaning As RequiredDo not Clean with Steel Wool Pads Interior Cleaning As RequiredCondenser Cleaning Every 3 Months Self Cleaning Every 6 Months Inlet Screen Cleaning Every Year Draining for NON-USE Storage, Vacation and MovingBefore YOU Call for Service TroubleshootingTroubleshooting Guide Problem Possible Cause Remedy If Service is RequiredPeriod WE will Responsible for Full ONE-YEAR Warranty Information
Top Page Image Contents