Electrolux E15IM60E manual Condenser Cleaning Every 3 Months

Page 27

Maintenance 27

Condenser Cleaning — Every 3 Months

To maintain operational efficiency, clean the condenser every three months (depending on environmental conditions, more or less frequent cleaning may be necessary).

!WARNING

Disconnect electric power to the ice maker before cleaning the condenser.

To remove and replace the grille for access to the condenser fins follow this procedure (see Figure 32):

1Remove the screws at each end of the grille.

2Remove the grille.

!WARNING

CONDENSER

Figure 32

DO NOT touch the condenser fins. The condenser fins are SHARP. The fins can also be easily damaged.

!CAUTION

DO NOT use any type of cleaner on the condenser unit.

3Clean the condenser coil using a brush with a “combing” action, or a vacuum cleaner. Do not touch the condenser coil.

4Position the grille to align the screw holes with the cabinet.

5Insert the grille screws and tighten. Do not over tighten.

Image 27

Contents Use & Care Guide Finding Information Please Read and Save this GuideMake a Record for Quick Reference QUESTIONS? Product Registration CardDefinitions SafetyImportant Safety Instructions Safety PrecautionsGeneral Precautions Installation Dimensions InstallationGravity Drain Drain InstallationInstalling the Drain Ice Makers With Factory Installed Drain PumpBack View Drain Pump Connection Connecting a Drain PumpPreparing the Site Site PreparationCabinet Or Wall Door Swing Clearance Needed Water Supply Connection Connecting the Water SupplyUL134 Leveling the Unit LevelingReversing the Door Some Models Door ReversalHinge Screw PIN DoorAdjustment Adjusting the DoorTo adjust Door Closers Boss Table of Contents Installing a BUILT-IN Built-In InstallationInitial START-UP Start-upOperation Normal OperationIce Cube Thickness ICE Dispenser Operation & Care Sample Area Special Considerations MaintenanceMaintaining and Cleaning Your Icemaker Exterior Cleaning As RequiredDo not Clean with Steel Wool Pads Interior Cleaning As RequiredCondenser Cleaning Every 3 Months Self Cleaning Every 6 Months Inlet Screen Cleaning Every Year Draining for NON-USE Storage, Vacation and MovingTroubleshooting Before YOU Call for ServiceTroubleshooting Guide Problem Possible Cause Remedy If Service is RequiredPeriod WE will Responsible for Full ONE-YEAR Warranty Information