Electrolux E15IM60E Maintenance, Special Considerations, Maintaining and Cleaning Your Icemaker

Page 25

Maintenance 25

SPECIAL CONSIDERATIONS

•For best performance, keep the unit out of direct sunlight.

•Turn the unit OFF and dispose of any ice cubes if the unit will not be used for 5 days or more. Prop door open to allow for air circulation and prevent mold and mildew.

•If the ambient temperature is expected to drop below 45°F (7°C), drain all water from the unit to prevent freezing damage not covered by the warranty.

•High ambient temperatures, 110°F (43°C) or higher, may reduce the unit’s ability to reach low temperatures and may also reduce the ice production rate.

MAINTAINING AND CLEANING YOUR ICEMAKER

Periodic cleaning and proper maintenance will ensure efficiency, top performance, and long life. The maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you have pets or other special considerations.

Exterior Cleaning - As Required

The door, grille and cabinet may be cleaned with a mild detergent and warm water solution. Do not use solvent based or abrasive cleaners.

Use a soft sponge and rinse with clean water. Wipe with a soft, clean towel to prevent water spotting.

Stainless Steel Models

•Stainless steel models may discolor when exposed to chlorine gas, pool chemicals, salt water or cleaners with bleach.

•Keep your stainless unit looking new by cleaning with a high quality, all-in-one stainless steel cleaner/polish on a monthly basis. Frequent cleaning will remove surface contamination that could lead to rust. Some installations will require cleaning on a weekly basis.

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Use & Care Guide Please Read and Save this Guide Finding InformationMake a Record for Quick Reference QUESTIONS? Product Registration CardImportant Safety Instructions SafetySafety Precautions DefinitionsGeneral Precautions Installation Dimensions InstallationInstalling the Drain Drain InstallationIce Makers With Factory Installed Drain Pump Gravity DrainBack View Drain Pump Connection Connecting a Drain PumpPreparing the Site Site PreparationCabinet Or Wall Door Swing Clearance Needed Water Supply Connection Connecting the Water SupplyUL134 Leveling the Unit LevelingReversing the Door Some Models Door ReversalHinge Screw PIN Adjusting the Door DoorAdjustmentTo adjust Door Closers Boss Table of Contents Installing a BUILT-IN Built-In InstallationInitial START-UP Start-upNormal Operation OperationIce Cube Thickness ICE Dispenser Operation & Care Sample Area Maintaining and Cleaning Your Icemaker MaintenanceExterior Cleaning As Required Special ConsiderationsDo not Clean with Steel Wool Pads Interior Cleaning As RequiredCondenser Cleaning Every 3 Months Self Cleaning Every 6 Months Inlet Screen Cleaning Every Year Draining for NON-USE Storage, Vacation and MovingBefore YOU Call for Service TroubleshootingTroubleshooting Guide Problem Possible Cause Remedy If Service is RequiredPeriod WE will Responsible for Full ONE-YEAR Warranty Information
Top Page Image Contents