Electrolux E15IM60E manual Hinge Screw PIN

Page 16

Door Reversal 17

3Remove top hinge (3 screws), reinstall hinge screw pin, and remount on opposite side BOTTOM (see Figure 17).

4Remove the two door closer inserts from the existing bottom hinge and install as shown on the new bottom hinge (see Figure 18).

5Remove existing bottom hinge (3 screws) and remount on opposite side TOP. Remove hinge screw pin.

6With bottom of door facing up, remove pivot plate (2 screws), flip over, and remount on opposite side of door (see Figure 19).

7Holding door upright with top of door tilted forward, place hole of door pivot plate on bottom hinge screw pin (see Figure 20). Be sure that the bosses on the closers align with holes in hinge and hinge plate.

8Tilt top of door into position in top hinge and install top hinge screw pin.

9In empty hinge holes, install plastic screw plugs (3 top and 3 bottom) and door hole plug (1,door top) removed in step 2.

HINGE

SCREW

PIN

Figure 17

UL313

DOOR

CLOSER

INSERTS

Figure 18	BOSS
	UL312
Figure 19	UL319

Figure 20

BOSS

CLRCO008

Image 16

Contents Use & Care Guide Please Read and Save this Guide Finding InformationMake a Record for Quick Reference Product Registration Card QUESTIONS?Safety Important Safety InstructionsSafety Precautions DefinitionsGeneral Precautions Installation Installation DimensionsDrain Installation Installing the DrainIce Makers With Factory Installed Drain Pump Gravity DrainBack View Connecting a Drain Pump Drain Pump ConnectionSite Preparation Preparing the SiteCabinet Or Wall Door Swing Clearance Needed Connecting the Water Supply Water Supply ConnectionUL134 Leveling Leveling the UnitDoor Reversal Reversing the Door Some ModelsHinge Screw PIN Adjusting the Door DoorAdjustmentTo adjust Door Closers Boss Table of Contents Built-In Installation Installing a BUILT-INStart-up Initial START-UPNormal Operation OperationIce Cube Thickness ICE Dispenser Operation & Care Sample Area Maintenance Maintaining and Cleaning Your IcemakerExterior Cleaning As Required Special ConsiderationsInterior Cleaning As Required Do not Clean with Steel Wool PadsCondenser Cleaning Every 3 Months Self Cleaning Every 6 Months Inlet Screen Cleaning Every Year Storage, Vacation and Moving Draining for NON-USEBefore YOU Call for Service TroubleshootingTroubleshooting Guide If Service is Required Problem Possible Cause RemedyWarranty Information Period WE will Responsible for Full ONE-YEAR