Electrolux E15IM60E manual UL134

Page 13

14Water Supply Connection

Figure 8

UL134

Figure 9

Figure 10

1Locate the compression fitting and ferrule packed in the unit. Slide the compression fitting and ferrule over the 1/4 inch water supply line. Do not use thread sealing compound or tape. Using two wrenches, tighten the compression fitting on the supply line (see Figure 8).

2Carefully bend the water supply line into position and connect the line to the solenoid valve (see Figure 9). Avoid kinking the water supply line.

3For recessed installations, allow extra water supply line length to provide slack for easy removal from the recessed area (see Figure 10). This will also safeguard against kinking the line.

!CAUTION

After completing the installation, turn on the water and recheck water and drain connection for leaks. Apply additional tightening if needed. Do NOT use thread sealing com-pound or tape.

4Plug in the power cord.

5Gently push the unit into position. If desired the unit may be recessed into cabinet or wall.

6Allow at least 1-1/2 inches clearance behind the unit for electrical, water supply and drain connections.

Image 13

Contents Use & Care Guide Please Read and Save this Guide Finding InformationMake a Record for Quick Reference QUESTIONS? Product Registration CardImportant Safety Instructions SafetySafety Precautions DefinitionsGeneral Precautions Installation Dimensions InstallationInstalling the Drain Drain InstallationIce Makers With Factory Installed Drain Pump Gravity DrainBack View Drain Pump Connection Connecting a Drain Pump Preparing the Site Site PreparationCabinet Or Wall Door Swing Clearance Needed Water Supply Connection Connecting the Water SupplyUL134 Leveling the Unit LevelingReversing the Door Some Models Door ReversalHinge Screw PIN Adjusting the Door DoorAdjustmentTo adjust Door Closers Boss Table of Contents Installing a BUILT-IN Built-In InstallationInitial START-UP Start-upNormal Operation OperationIce Cube Thickness ICE Dispenser Operation & Care Sample Area Maintaining and Cleaning Your Icemaker MaintenanceExterior Cleaning As Required Special ConsiderationsDo not Clean with Steel Wool Pads Interior Cleaning As RequiredCondenser Cleaning Every 3 Months Self Cleaning Every 6 Months Inlet Screen Cleaning Every Year Draining for NON-USE Storage, Vacation and MovingBefore YOU Call for Service TroubleshootingTroubleshooting Guide Problem Possible Cause Remedy If Service is RequiredPeriod WE will Responsible for Full ONE-YEAR Warranty Information