Electrolux E15IM60E manual Storage, Vacation and Moving, Draining for NON-USE

Page 30

30Storage, Vacation and Moving

DRAINING FOR NON-USE

If the unit is to be stored, moved or not used for extended periods, it will be necessary to drain the system of water.

!WARNING

Electrical Shock Hazard. Disconnect power before servicing. Before operating replace all panels. Failure to do so can result in death or electrical shock.

1Disconnect power from the unit.

2Remove ice from the storage bin.

3Shut off water supply at the main water source.

NOTE

Back panel must be removed prior to disconnecting the water lines.

4Disconnect the inlet and outlet lines to the water valve and allow them to drain.

!CAUTION

If the ambient temperature is expected to drop below 45°F (7°C), drain all water from the unit to prevent freezing damage, which is not covered by the warranty.

IMPORTANT

The use of anti-freeze or other products of this nature is not necessary and is not recommended.

5Reconnect inlet and outlet lines to the water valve.

6Replace back panel.

7Drain water from the water trough and drain line by removing the overflow tube (see Figure 34).

8Clean the ice maker and storage bin before next use.

9Prop door open to allow for air circulation and prevent mold and mildew.

IMPORTANT

It is possible that dirt or scale will dislodge in the water line. Always throw away all ice cubes made during the first 24 hours of operation when the unit is returned to service.

Page 29 Page 31
Image 30
Page 29 Page 31
Contents Use & Care Guide Finding Information Please Read and Save this GuideMake a Record for Quick Reference Product Registration Card QUESTIONS?Safety Precautions SafetyImportant Safety Instructions DefinitionsGeneral Precautions Installation Installation DimensionsIce Makers With Factory Installed Drain Pump Drain InstallationInstalling the Drain Gravity DrainBack View Connecting a Drain Pump Drain Pump ConnectionSite Preparation Preparing the SiteCabinet Or Wall Door Swing Clearance Needed Connecting the Water Supply Water Supply ConnectionUL134 Leveling Leveling the UnitDoor Reversal Reversing the Door Some ModelsHinge Screw PIN DoorAdjustment Adjusting the DoorTo adjust Door Closers Boss Table of Contents Built-In Installation Installing a BUILT-INStart-up Initial START-UPOperation Normal OperationIce Cube Thickness ICE Dispenser Operation & Care Sample Area Exterior Cleaning As Required MaintenanceMaintaining and Cleaning Your Icemaker Special ConsiderationsInterior Cleaning As Required Do not Clean with Steel Wool PadsCondenser Cleaning Every 3 Months Self Cleaning Every 6 Months Inlet Screen Cleaning Every Year Storage, Vacation and Moving Draining for NON-USETroubleshooting Before YOU Call for ServiceTroubleshooting Guide If Service is Required Problem Possible Cause RemedyWarranty Information Period WE will Responsible for Full ONE-YEAR
Top Page Image Contents