We are delighted that you have chosen the InSinkErator® Instant Hot Water Dispenser to be a part of your home. This unique appliance will save you time and effort in the kitchen, and you’ll enjoy discovering new uses for it each day. That’s exactly why millions of people are now using an InSinkErator Instant Hot Water Dispenser.
We are confident that by following our
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
Identify the model of your instant hot water dispenser and record it here:________________
HOW TO USE THIS INSTRUCTION MANUAL
These instructions are separated into main sections, indicated by numbers, and subsections, indicated by capital letters. The manual is setup this way to allow you to take a break at any point after completing a section or subsection without affecting the installation process.
■ For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing or using this |
instant hot water dispenser. |
■ This particular unit is not intended for commercial use. |
■ Make sure that all electrical wiring and connections conform to local codes. |
■ A standard |
■ The wall outlet powering your dispenser must have power supplied to it continuously. |
■ This outlet must be fused and should not be controlled by the same wall switch that operates the disposer, unless you |
have a SinkTop Switch™ from InSinkErator®. |
■ It is recommended that a dedicated control valve be installed on the cold water line supplying water to this system. |
What you’ll see in the instruction manual:
INSTALLING THE FAUCET - View/Wave
A | View / Wave |
Unpack dispenser components.
2 | On a firm, flat surface, carefully |
|
straighten the copper tubing. |
| |
|
| |
3 | Remove the wing nut from | 1 |
| the valve body. |
Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing.
■ If you suspect elevated levels of chlorine in your water, or your water has a rusty appearance before the installation |
of this unit, it is recommended to use our water filtration system. |
This product contains stainless steel. The manufacturer cannot guarantee against rusty water because of the |
number of factors that are involved beyond the manufacturer’s control. However, the sudden appearance of rusty |
water discharged from the hot water dispenser may indicate the need for service or replacement of this product. |
■ The use of a water filter should NOT result in the water pressure to drop below 30 psi (207kPa). |
If it does, this will prevent your unit from operating properly. |
■ Moving parts inside the tank causing a rattling noise is normal. |
WHAT YOU NEED TO GET STARTED
Equipment Required:
■ Drill | ■ Phillips and flat blade screwdrivers |
■ | ■ Pencil |
■ Dedicated control valve | ■ Tape measure |
■ Adjustable wrench | ■ Level |
Equipment You May Need:
■ Anchors for drywall | ■ Basin wrench |
■ Hole saw | ■ Hole punch |
If you intend to use the sprayer hole in your sink for your dispenser, you may need a basin wrench and a 1/8" plug or a 1/4" cap (not supplied) for the faucet spray hose line. See Step
If you need to cut a mounting hole in your stainless steel sink, you may need a 11⁄4" - 11⁄2" hole saw made for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface other than stainless steel.
2
1Provides a
2Contains simple illustrations that provide visual instruction to support the narrative.
3CAUTIONS, WARNINGS and DANGERS that will require your attention during the step.
An imminently hazardous situation, which, if not avoided, will result in death or serious injury.
A potentially hazardous situation, which, if not avoided, could result in death or serious injury.
A potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
OVERVIEW OF A
COMPLETED SETUP
3