2 A | INSTALLING THE FAUCET - VIEW/ WAVE |
View/Wave | |
| ■ Unpack dispenser components. |
| ■ On a firm, flat surface, carefully |
| straighten the copper tubing using |
| hands only. |
Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing.
2 A | INSTALLING THE FAUCET - H990 |
H990 | |
| ■ Unpack dispenser components. |
| ■ On a firm, flat surface, carefully |
| straighten the copper tubing using |
| hands only. |
Property Damage: Do not pinch or break copper tubing. Do not distort the last 1 inch of tubing.
B
15⁄8" Small
Steel Washer
15⁄8" Small
Rubber Washer 
Standard 11⁄2" hole
15⁄8" Small
Steel Washer
15⁄8" Small 
Rubber Washer 
21⁄4" Large
Steel Washer
Hole larger than 11⁄2"
View/Wave
For a standard 11⁄2" sink/counter hole
■Feed tubes down through the hole in the sink/counter until the base is at rest. Set faucet at desired angle.
Large washer required for sink holes larger than 11⁄2" or for porcelain sinks with radius or beveled holes.
■ Before feeding tubes through sink |
hole, remove extension. Place 21⁄4" |
B
H990
■ Ensure that the black rubber gasket |
is properly seated into the base of |
the dispenser head and will |
surround the sink mount. |
■ Feed tubes down the hole in the |
sink or countertop until the base is |
Faucet is
large steel washer over threads on |
faucet base. Reinstall extension. |
Make sure to use rubber gasket
to ensure proper seal.
at rest on the sink or countertop |
surface. |
C
Star Nut
Fiber
Washer 
Hot & Cool models only
View/Wave
■From under sink, slide 21⁄4" fiber washer over threaded extension. Thread star nut onto extension until snug.
Hot & Cool models only
■ Attach the quick connector to the ends |
of the copper tubes running from the |
dispenser. |
C
H990
■ From under the sink, place the |
threaded stud. |
■ Place wing nut onto the threaded |
stud. Make sure faucet head is at the |
desired angle. Tighten the wing nut |
An assistant may be needed to hold
the dispenser head in place while securing the dispenser.
■ Install a white 3/8" tube into other end |
of quick connector. |
An assistant may be needed to hold
the dispenser head in place while securing the dispenser.
until snug, while ensuring the semi- |
circular mounting plate extends |
beyond the sink hole. |
15⁄8" Small
Steel Washer
15⁄8" Rubber
Washer
Figure 1
Fiber
Washer
Figure 2
Star Nut
Installing into hole smaller than 11⁄2"
■ Unscrew and remove threaded extension |
from valve body. Do not discard, as you |
will need this later (See Figure 1). |
■ Leave small washers in place. |
■ Feed tubes down through the hole in |
the sink/counter until the base is at |
rest. Set faucet at desired angle. |
■ From under sink, slide 21⁄4" fiber washer |
over faucet base. Reinstall threaded |
If sink/counter thickness exceeds 3/4" a hole diameter of 11⁄2" is required.
extension onto the base until snug. |
Thread star nut onto extension until |
snug (See Figure 2). |
6 | 7 |