Emerson h990 owner manual Components in this Package, Preparation

COMPONENTS IN THIS PACKAGE

START HERE PROPER INSTALLATION SHOULD TAKE ABOUT 2-4 HOURS

					3/8" Tube
					Brass Nut / Ferrule /
					Tube Insert
HC-View-SS	Extension & Star Nut		3/4" Screws (2)		Quick Connector
	Washers
	1-5/8"	1-5/8"	2-1/4"	2-1/4"
HC-Wave-SS	Rubber	Small Steel	Large Steel	Fiber	Snap-Connect	Tank
					Fitting (3 pieces)

1	PREPARATION
	A	Required minimum from		Maximum counter
		center of hole to wall		thickness (depth)
	HC-View-SS		25⁄8"	3"
	H-View-SS		25⁄8"	3"
	HC-Wave-SS ....		25⁄8"	3"
	H-Wave-SS		23⁄8"	3"
	H990-SS		11⁄4"	3"
	H770-SS		2"	3⁄4"

■Identify locations for the dispenser faucet, tank and filter (if applicable).

■Check to make sure there is proper clearance (see chart at left) for dispenser handles to be fully opened.

■Check to make sure counter is not too thick (see chart at left).

■Make sure there is a grounded electrical outlet under the sink.

The wall outlet for your dispenser must have power supplied to it continuously and must be fused. It should not be controlled by the same wall switch

that operates your disposer, unless using an InSinkErator SinkTop SwitchTM.

H-View-SS	Extension & Star Nut		3/4" Screws (2)
	Washers
	1-5/8"	1-5/8"	2-1/4"	2-1/4"
H-Wave-SS	Rubber	Small Steel	Large Steel	Fiber	Snap-Connect	Tank
					Fitting (3 pieces)

3/4" Screws (2)

B

If you have to drill through sink or

countertop, you may need to rent or purchase

the appropriate tools.

■Turn off water supply.

■If using the sink sprayer hose hole, remove nut that connects sprayer hose at bottom of faucet.

■Using adjustable wrench, remove nut connecting sprayer washer flange in sprayer hole.

■Plug hose opening with either a 1/8" plug or a 1/4" cap (not supplied).

H990-SS	Semi-Circular		Snap-Connect	Tank
	Mounting Plate	Wing Nut	Rubber Gasket Fitting (3 pieces)

			3/4" Screws (2)
		Metal	Snap-Connect
H770-SS	Fiber Gasket	Mounting Plate	Mounting Screw Fitting (3 pieces)	Tank

C

Required Hole Size

11⁄4" - 11⁄2"

Dependent on model

Consult a professional before drilling into

a surface other than stainless steel.

What if you don’t have a sprayer hole or don’t want to use it?

■Many homeowners replace the soap dispenser in their sink with an instant hot water dispenser.

■If drilling a hole into a stainless steel sink or counter top, you can cut a mounting hole for the dispenser with a hole saw for stainless steel, or you can use a hole punch.

4 5