LEG/CASTER ASSEMBLY
The range is shipped fully assembled, except for the legs. The range is provided with four 6"(152 mm) adjustable stainless steel legs (hardware included), packaged in a box located inside of the oven. A set of four 6"(152 mm) casters are available as an optional field installable accessory.
Installation of legs/casters:
1.Carefully tip range on its side.
2.Align holes in leg/caster mounting plate with
3.Attach mounting plate to bottom of range using four ¼ - 20 x ⅝“ self tapping screws (provided). If casters are being installed, the two locking casters should be mounted on the front.
4.After all four legs/casters have been installed, carefully return the range to its upright position.
(For additional leg information, see Leveling section of this manual).
Ranges mounted on casters must use a flexible connector (not supplied by Wolf) that complies with the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69•CSA 6.16 and a
If disconnection of the restraint is necessary, turn off the gas supply before disconnection. Reconnect this restraint prior to turning the gas supply on and returning the range to its installation position.
If the range is installed on casters and is moved for any reason, it is recommended that the range be
LEVELING
To level the range, place a carpenter's level on the range top and check leveling of the unit side to side and front to rear. Achieve leveling by turning each foot section of the unit's leg as needed. Turning the foot in a counter clockwise direction will increase height and clockwise will decrease.
GAS PRESSURE REGULATOR
A preset gas pressure regulator and street elbow is shipped attached to the gas inlet of the range. This regulator must be installed by an authorized service person before the unit is placed into operation. See unit data plate, riveted inside the lower front kick panel, for pressure regulator setting information.
1.Locate the ¾" (19 mm) NPT gas connection pipe protruding through the back of the unit.
2.Cover the pipe threads with pipe joint compound resistant to propane gases.
3.Screw the regulator onto the pipe hand tight with flow direction arrow pointing towards the back of the unit and the regulator adjustment in the up right position.
4.With a pipe wrench, tighten the regulator securely in the upright position. (The regulator is preset and should not require any additional adjustments.) The pressure regulator must be mounted
-5 -