Breville BES840XL manual Troubleshooting, Using the Allen KEY

CARE & CLEANING

USING THE ALLEN KEY

Over time, the silicone seal surrounding the shower screen will need to be replaced to ensure optimum brewing performance.

1.Press the POWER button to turn the machine Off and unplug the cord from the power outlet.

2.Carefully remove the rear water tank and drip tray, taking particular care if they are full.

3.Using a skewer or similar, clean

the center of the screw of any residual coffee.

4.Insert the shorter end of the Allen Key into the center of the screw. Turn counter-clockwise to loosen the screw.

Clean center of screw before inserting Allen Key

5.Once loosened, carefully remove and retain the screw and stainless steel shower screen. Make note of the side of the shower screen that is facing downwards. This will make re-assembly easier. Wash the shower screen in warm soapy water, then dry thoroughly.

6.Remove the silicone seal with your fingers or a pair of long-nose pliers. Insert the new seal, flat side first, so the ribbed side is facing you.

7.Re-insert the shower screen, then the screw. With your fingers, turn the screw clockwise for 2-3 revolutions then insert the Allen Key to tighten until the screw is flush with the shower screen. Do not overtighten screw.

8.Re-insert the drip tray and rear water tank.

Contact Breville Consumer Support or visit www.breville.com for replacement silicone seals or for advice.

TROUBLESHOOTING

28