KitchenAid W10417002A manual Style, Connect to Water Line, Connect to Refrigerator

Page 11

INSTALLATION INSTRUCTIONS

Connect to Water Line

IMPORTANT: If you turn the refrigerator on before the water is connected, turn the ice maker OFF.

1.Unplug refrigerator or disconnect power.

2.Turn OFF main water supply. Turn ON nearest faucet long enough to clear line of water.

3.Use a quarter-turn shutoff valve or the equivalent, served by a ¹⁄₂" household supply line.

NOTE: To allow sufficient water flow to the refrigerator, a minimum ¹⁄₂" size household supply line is recommended.

A

B

C

 

D

A. Sleeve

C. Copper tubing (to refrigerator)

B. Nut

D. Household supply line (½" minimum)

4.Now you are ready to connect the copper tubing to the shutoff valve. Use ¹⁄₄" (6.35 mm) OD soft copper tubing to connect the shutoff valve and the refrigerator.

Ensure that you have the proper length needed for the job. Be sure both ends of the copper tubing are cut square.

Slip compression sleeve and compression nut onto copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten.

A B

C

A. Compression sleeve

C. Copper tubing

B. Compression nut

 

5.Place the free end of the tubing into a container or sink, and turn on main water supply to flush out tubing until water is clear. Turn off shutoff valve on the water pipe.

NOTE: Always drain the water line before making the final connection to the inlet of the water valve, to avoid possible water valve malfunction.

6.Bend the copper tubing to meet the water line inlet, which is located on the back of the refrigerator cabinet as shown. Leave a coil of copper tubing to allow the refrigerator to be pulled out of the cabinet or away from the wall for service.

Connect to Refrigerator

Follow the connection instructions specific to your model.

Style 1

1.Remove plastic cap from water valve inlet port. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. Confirm copper tubing is secure by pulling on copper tubing.

2.Create a service loop with the copper tubing. Avoid kinks when coiling the copper tubing. Secure copper tubing to refrigerator cabinet with a “P” clamp.

A

B

C

D

A. Copper tubing

C. Compression nut

B. “P” clamp

D. Compression sleeve

3.Turn on water supply to refrigerator and check for leaks. Correct any leaks.

Style 2

1.Unplug refrigerator or disconnect power.

2.Remove and discard the short, black plastic part from the end of the water line inlet.

3.Thread the nut onto the end of the tubing. Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

NOTE: To avoid rattling, be sure the copper tubing does not touch the cabinet’s side wall or other parts inside the cabinet.

A

B

C

D

A. Line to refrigerator

 

C. Sleeve (purchased)

B. Nut (purchased)

 

D. Supplied line from refrigerator

11

Image 11
Contents French Door Bottom Mount Refrigerator USE & Care Guide Table of Contents Before You Throw Away Your Old Refrigerator or Freezer Refrigerator SafetyWhat’s New Behind the Doors? Parts and FeaturesLocation Requirements Installation InstructionsClean Before Using Unpack the RefrigeratorRemove and Replace Refrigerator Doors Door Removal and ReplacementRemove Left-Hand Refrigerator Door Remove Right-Hand Refrigerator DoorFinal Steps Replace Right-Hand Refrigerator DoorReplace Left-Hand Refrigerator Door Tool Needed ¹⁄₄ hex driver Remove and Replace Freezer Drawer FrontRemove Drawer Front Replace Drawer FrontRecommended Grounding Method Electrical RequirementsWater Supply Requirements Connect the Water SupplyConnect to Refrigerator StyleConnect to Water Line Install Handles Handle Installation and RemovalComplete the Installation Remove the Handles Refrigerator Leveling, Door Closing and AlignmentTo Steady the Refrigerator To Adjust the Cabinet TiltStyle To Align the DoorsWater Filter Status Light Filters and AccessoriesInstall the Water Filter Water Filtration SystemReplace the Water Filter Install Air Filter on some modelsInstalling the Air Filter Installing the Filter Status IndicatorModels without notches Install Produce Preserver on some modelsInstalling the Produce Preserver Replacing the Air FilterOpening and Closing Doors AccessoriesInstalling the Status Indicator Refrigerator USEViewing and Adjusting Temperature Set Points Using the ControlsView Temperature Set Points Adjust Temperature Set PointsWater Filter Status Save/Confirm Temperature SettingsMax Cool Max IceShowroom Mode Sabbath ModeVacation Mode Door Ajar AlarmFlush the Water System Water and Ice DispensersTo Dispense Water Standard To Dispense Water Measured FillTo Dispense Ice To Clean the Ice Dispenser ChuteTurn the Ice Maker On/Off Ice Maker and Ice Storage Bin on some modelsRemove and Replace the Ice Storage Bin Tuck Away Shelf on some models Refrigerator ShelvesShelves and Shelf Frames Crisper and Crisper Cover Refrigerator FeaturesTemperature-Controlled Drawer on some models Meat Storage Guide Door BinsPizza Pocket and Drawer Divider Drawer DividerStyle 2 Stainless Steel CleaningRefrigerator Care Style 1 Smooth DoorIf You Choose to Turn Off the Refrigerator Before You Leave LightsVacation and Moving Care Operation TroubleshootingTo possibly avoid the cost of a service call Problem Possible Causes SolutionsNoise Problem Possible Causes Temperature and MoistureThere is interior moisture buildup ProblemPossible Causes Solutions Ice and WaterColor in the ice or water SmallOff-taste, odor or gray Ice dispenser jams Water and iceDispenser will not Operate properlyDoors Water Filter Certifications Water Filtration System Performance Data SheetThis limited warranty does not cover WarrantyLimited Warranty Items Excluded from WarrantyAU CA N a D a Table DES Matières Votre sécurité et celle des autres est très importante Sécurité DU RéfrigérateurAvant de jeter votre vieux réfrigérateur ou congélateur Pièces ET CaractéristiquesQuoi de neuf en coulisse? Pièces ET CaractéristiquesNettoyage avant l’utilisation Instructions D’INSTALLATIONDéballage du réfrigérateur Dépose des matériaux d’emballageRetrait et réinstallation des portes du réfrigérateur Exigences demplacementRetrait et réinstallation des portes Retrait de la porte de gauche du réfrigérateur Retrait de la porte de droite du réfrigérateurRemarques Réinstallation de la porte de droite du réfrigérateurRéinstallation de la porte de gauche du réfrigérateur Étapes finalesRetrait de lavant du tiroir Réinstallation de lavant du tiroirRaccordement à la canalisation deau Méthode recommandée de mise à la terreSpécifications électriques Spécifications de l’alimentation en eauRaccordement au réfrigérateur Raccordement à la canalisation deauInstallation des poignées Installation et démontage des poignéesAchever linstallation Démontage des poignées Stabilisation du réfrigérateur Pour régler l’inclinaison du réfrigérateurAlignement des portes Témoin lumineux du filtre à eau Filtres ET AccessoiresInstallation du filtre à eau Système de filtration deauInstallation du filtre à air Installation du filtre à air sur certains modèlesRemplacement du filtre à eau Installation du témoin de statut de filtreSensibilité à Production Léthylène Déthylène Remplacement du filtre à airInstallation du conservateur pour produits frais Modèles sans encochesRemplacement du sachet de conservation pour produits frais AccessoiresInstallation du témoin Ouverture et fermeture des portes Utilisation des commandesUtilisation DU Réfrigérateur Mise en marche/arrêt du refroidissement Voir les points de réglage de températureAjustement des points de réglage de température Sauvegarder/Confirmer les réglages de températureTémoin lumineux de létat du filtre Max Cool refroidissement maximalMax Ice production glaçons maximale Avertisseur de porte entrouverte Mode SabbatMode vacances Mode Showroom expositionRinçage du circuit deau Distributeurs deau et de glaçonsDistribution deau standard Distribution deau remplissage mesuréPlateau dégouttement du distributeur Distribution de glaçonsNettoyage du goulot de distributeur à glaçons Le distributeur de glaçonsMise en marche/arrêt de la machine à glaçons Lumière du distributeurDispositif de verrouillage du distributeur Taux de production des glaçonsMise en marche/arrêt de la machine à glaçons Retrait et réinstallation du bac dentreposage à glaçonsTablettes du réfrigérateur Tablette escamotable sur certains modèles Caractéristiques DU RéfrigérateurBac à légumes et couvercle du bac à légumes Tablettes et cadres de tablettesTiroir à température contrôlée sur certains modèles Commande de températures prérégléesCommande de température personnalisée Dépose et réinstallation du tiroirGuide d’entreposage des viandes Dépose et réinstallation des balconnetsBalconnets de porte Espace à pizza et cloison de tiroirStyle 2 Acier inoxydable Entretien DU RéfrigérateurNettoyage Style 1 Porte lisseNettoyage du condensateur LampesEntretien avant les vacances ou lors d’un déménagement Nettoyage de l’intérieurLe réfrigérateur ne Problème Causes Possibles SolutionsDépannage FonctionnementBruits Basse dans le réfrigérateur Température et humiditéLa température est trop ÉlevéeProblème Causes Possibles SolutionsGlaçons et eau Odeur ou couleur grise des Les glaçons sont creux ouPetits Mauvais goût, mauvaiseDe leau suinte ou goutte Le distributeur de glaçonsSe bloque lorsquil distribue De la glace concasséePortes Système de filtration d’eau Feuille DE Données SUR LA PerformanceGarantie DU Réfrigérateur Kitchenaid GarantiePage Page Benton Harbor, MI KitchenAid Brand Home AppliancesCustomer eXperience Center Benson Road