6.To select a new volume or start dispensing the same volume again, you must first finish dispensing the selected volume, or turn off the Measured Fill feature (either by waiting 1 minute so it will automatically turn off or by pressing ICE MODE to manually turn it off) and then turn it back on.
The Ice Dispenser
Ice dispenses from the ice maker storage bin. To turn off the ice maker, see “Ice Maker and Storage Bin.”
The dispenser may continue to make noise and ice may continue to dispense for several seconds after releasing the dispenser button or paddle.
IMPORTANT: If the ice cubes are hollow or have an irregular shape, it could be because of low water pressure. See “Water Supply Requirements.”
To Clean the Ice Dispenser Chute:
Humidity causes ice to naturally clump together. Ice particles can build up until the ice dispenser chute becomes blocked.
If ice is not dispensed regularly, it may be necessary to empty the ice storage bin and clean the ice delivery chute, the ice storage bin and the area beneath the storage bin every 2 weeks.
■If necessary, remove the ice clogging the storage bin and delivery chute, using a plastic utensil.
■Clean the ice delivery chute and the bottom of the ice storage bin using a warm, damp cloth and dry thoroughly.
To Dispense Ice:
WARNING
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
IMPORTANT: You do not need to apply a lot of pressure to the paddle to activate the ice dispenser. Pressing hard will not make the ice dispense faster or in greater quantities.
1.Press ICE MODE to select cubed ice (default) or crushed ice. The display screen indicates which type of ice is selected.
CRUSHED CUBED
2.Press a sturdy glass against the dispenser paddle. Remove the glass to stop dispensing. Hold the glass close to the dispenser opening so ice does not fall outside of the glass.
NOTE: When changing from crushed to cubed, a few ounces of crushed ice will be dispensed along with the first cubes.
REFRIGERATOR USE
The Dispenser Drip Tray
There is an insert in the dispenser drip tray. The insert can be removed from the drip tray to carry to the sink to empty or clean.
■Push down on the rear edge of the insert to tilt up the front edge for easy removal.
A 
A. Dispenser tray insert
The Dispenser Light
When you use the dispenser, the light will automatically turn on.
To turn on the light when you are not dispensing:
Press LIGHT to toggle through the following choices in a continuous loop:
■OFF (default): The dispenser light is off.
■ON: The dispenser light is on at 100% brightness
■DIM: The dispenser light is on at 50% brightness
The dispenser lights are LEDs that cannot be changed. If it appears that your dispenser lights are not working, see “Troubleshooting” for more information.
The Dispenser Lock
The dispenser can be disabled for easy cleaning or to avoid unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off power to the refrigerator, to the ice maker, or to the dispenser light. It simply deactivates the controls and dispenser levers. To turn off the ice maker, see “Ice Maker and Storage Bin.”
■Press and hold LOCK for 3 seconds to lock the dispenser.
■Press and hold LOCK for 3 seconds to unlock the dispenser. The display screen indicates when the dispenser is locked.
LOCKED UNLOCKED
23