REFRIGERATOR USE
Ice Maker and Ice Storage Bin (on some models)
IMPORTANT: To avoid low ice production and poor quality ice, flush the water system before turning on the ice maker. See “Water Dispenser.”
■Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. Allow 2 to 3 days for the storage bin to fill completely following installation.
■The quality of your ice will be only as good as the quality of the water supplied to your ice maker. Avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained.
■If the ice in the storage bin clumps together, break up ice using a plastic utensil and discard. Do not use anything sharp to break up the ice. This can cause damage to the ice bin and the dispenser mechanism.
■Do not store anything in the ice storage bin.
Ice Production Rate
■The ice maker should produce approximately 3 lbs (1.4 kg) of ice per day under normal operation.
■To increase ice production, select the increased ice production feature from the Options menu on the control panel. See “Using the Control(s).”
Style 1 - Ice Maker in the Refrigerator (on some models)
The ice maker is located on the
Turn the Ice Maker On/Off
1.Push up on the latch on the
■Your ice maker has an automatic shutoff. The sensor will automatically stop ice production if the storage bin is full, if the door is open or the storage bin is removed. The control will remain in the ON (left) position.
A 
A. Ice storage bin release latch
3.Close the ice compartment door.
Remove and Replace the Ice Storage Bin
■Remove the ice storage bin by inserting your fingers into the hole at the base of the bin and squeezing the latch to release the bin from the compartment. Lift the storage bin up and pull it straight out.
■Replace the storage bin inside the ice compartment and push down to make sure it is firmly in place.
Style 2 - Ice Maker in the Freezer (on some models)
Turn the Ice Maker On/Off
To turn the ice maker ON, simply lower the wire shutoff arm.
To manually turn the ice maker OFF, lift the wire shutoff arm to the OFF (arm up) position and listen for the click.
NOTE: Your ice maker has an automatic shutoff. As ice is made, the ice cubes will fill the ice storage bin and the ice cubes will raise the wire shutoff arm to the OFF (arm up) position. Do not force the wire shutoff arm up or down.
A 
A. Ice compartment door latch
2.Turn on the ice maker by moving the switch to the (left) ON position.
NOTES:
■To manually turn off the ice maker, move the control to the OFF (right) position.
NOTE: Turn off the ice maker before removing the ice storage bin to serve ice or to clean the bin. This will keep the ice cubes from dropping out of the ice maker and into the freezer compartment. After replacing the ice storage bin, turn on the ice maker.
24