KitchenAid TX802RTDF-CU10-F-2 SERIES manual Unpack the Wine Cellar, Install Custom Overlay Frame

Page 6

Unpack the Wine Cellar

WARNING

Excessive Weight Hazard

Use two or more people to move and install wine cellar. Failure to do so can result in back or other injury.

A

B

C

D

Remove the Packaging

■Remove tape and glue residue from surfaces before turning on the wine cellar. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.

■Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your wine cellar. For more information, see “Wine Cellar Safety.”

■Dispose of/recycle all packaging materials.

When Moving Your Wine Cellar:

Your wine cellar is heavy. When moving the wine cellar for cleaning or service, be sure to cover the floor with cardboard or hardboard to avoid floor damage. Always pull the wine cellar straight out when moving it. Do not wiggle or “walk” the wine cellar when trying to move it, as floor damage could occur.

Clean Before Using

After you remove all of the packaging materials, clean the inside of your wine cellar before using it. See the cleaning instructions in “Wine Cellar Care.”

Install Custom Overlay Frame

IMPORTANT:

■Create custom overlay frame according to the specifications in the “Custom Overlay Frame” section.

■KitchenAid is not responsible for the removal or addition of molding or decorative panels that would not allow access to the appliance for service.

Remove the Door

IMPORTANT: Do not remove the grease from the washer, top spacer or top hinge pin. Be sure to set aside the top hinge, top spacer and washer for later use.

1.Using a Phillips screwdriver, remove the three screws from the top hinge. Remove the top hinge.

E

A. Screws (3)

D. Top spacer

B. Top hinge

E. Door

C.Washer

2.Remove the three screws from the top spacer. Remove the top spacer and washer.

3.Open the door. Lift the front of the door up, pulling straight out to remove as shown.

Attach the Overlay Frame

NOTE: If the overlay hooks are not installed, see “Custom Overlay Frame” for overlay hook locations.

1.Position the overlay frame ¹⁄₂" (1.27 cm) higher than the door. Be sure to position the overlay hooks to the pilot holes.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Table of Contents/Índice/Table des matières Wine CellarTable of Contents ÍndiceTable DES Matières Wine Cellar Safety Before You Throw Away Your Old Wine CellarTake off the door Install Overlay Hooks Installation InstructionsOverlay Frame Dimensions-Rear View Tools and PartsDoor Hinge Holes Electrical RequirementsLocation Requirements Recommended grounding methodInstall Custom Overlay Frame Unpack the Wine CellarDoor Closing Install the DoorDoor Closing Remove the masking tape from the doorBase Grille Using the ControlWine Cellar USE Normal SoundsWine Racks Stocking the Wine CellarLighting the Wine Cellar Changing the Light Bulb CleaningWine Cellar Care Vacation and Moving CareTroubleshooting U.S.A Assistance or ServiceAccessories CanadaItems Excluded from Warranty Kitchenaid Refrigerator WarrantyLimited Warranty This limited warranty does not coverSeguridad DE LA Bodega Antes de descartar su vieja bodegaMarco recubierto a la medida Instrucciones DE InstalaciónPiezas y herramientas Medidas del marco recubierto Vista posteriorOrificios de la bisagra de la puerta Requisitos eléctricosRequisitos de ubicación Método de conexión a tierra recomendadoCómo quitar los materiales de empaque Desempaque de la bodegaCómo instalar el marco recubierto La medida Limpieza antes del usoCómo fijar el marco recubierto Cómo instalar la puertaUSO DE LA Bodega Cierre de la puertaSonidos normales Uso del control PortabotellasCómo iluminar la bodega Cuidado DE LA BodegaCómo almacenar en la bodega LimpiezaPara cambiar el foco Cómo cambiar el focoCuidado durante las vacaciones Mudanzas VacacionesSolución DE Problemas En Canadá Ayuda O Servicio TécnicoEn los EE.UU AccesoriosExclusiones DE LA Garantía Garantía DEL Refrigerador DE KitchenaidGarantía Limitada Esta garantía limitada no cubrePage Sécurité DE LA Cave À VIN Avant de jeter votre vieille cave à vinOutillage et pièces Instructions D’INSTALLATIONInstallation des crochets pour cadre décoratif Cadre décoratif personnaliséSpécifications électriques Exigences d’emplacementMéthode recommandée de mise à la terre Trous de charnière de porteEnlèvement des matériaux d’emballage Installation du cadre décoratif personnaliséDéballage de la cave à vin Nettoyage avant l’utilisationInstallation de la porte Fixation du cadre décoratifÔter le ruban adhésif de masquage de la porte Fermeture de la porte Grille de la base Réinstallation de la grille de la baseUtilisation DE LA Cave VIN Sons normauxUtilisation de la commande Casiers à vinÉclairage de la cave à vin Entretien DE LA Cave À VINStockage dans la cave à vin NettoyageVacances Changement de lampoule déclairageChangement de lampoule DéménagementDépannage Aux États-Unis Assistance OU ServiceAccessoires Au CanadaÉléments Exclus DE LA Garantie Garantie DU Réfrigérateur KitchenaidGarantie Limitée La présente garantie limitée ne couvre pasPage 2300273D All rights reserved

TX802RTDF-CU10-F-2 SERIES specifications

The KitchenAid TX802RTDF-CU10-F-2 SERIES is a remarkable addition to the array of kitchen appliances designed to elevate culinary experiences. This versatile and powerful kitchen tool combines practicality with innovative technology to make cooking more enjoyable and efficient.

At the core of the TX802RTDF-CU10-F-2 SERIES is its robust motor that delivers consistent performance whether you are kneading dough, mixing batters, or whipping cream. The model boasts multiple speed settings, allowing users to select the appropriate speed for different tasks. This customization helps achieve perfect results, whether you're preparing a delicate meringue or mixing heavy cookie dough.

One of the standout features of this series is its generous mixing capacity. The large stainless-steel bowl is designed to handle significant quantities, making it ideal for both everyday cooking and larger gatherings. With a capacity of up to 10 quarts, this appliance can facilitate the preparation of multiple meals or tackle large baking projects with ease.

The TX802RTDF-CU10-F-2 SERIES incorporates advanced technologies such as the Tilt-Head Design, which allows easy access to the bowl and attachments. This feature makes it simple to add ingredients or change attachments without hassle. Additionally, the model is equipped with a variety of attachments, including a flat beater, dough hook, and wire whip, further enhancing its versatility in handling diverse kitchen tasks.

Another notable aspect of the KitchenAid Series is its durability and classic design. Constructed with high-quality materials, the appliance is not just built to withstand the rigors of daily use but also adds an aesthetic appeal to any kitchen décor. The finish options and sleek lines reflect a timeless elegance that can complement a variety of kitchen styles.

Safety and ease of use are also prioritized in the TX802RTDF-CU10-F-2 SERIES. Non-slip feet provide stability during operation, while a safety lock mechanism ensures that the motor does not accidentally engage when the bowl is not properly positioned.

In conclusion, the KitchenAid TX802RTDF-CU10-F-2 SERIES offers an unparalleled combination of power, capacity, and versatility. Whether you are a seasoned chef or a novice cook, this appliance is designed to make your time in the kitchen more enjoyable and productive. With its thoughtful engineering, robust performance, and classic design, it is undoubtedly a worthy investment for any culinary enthusiast.
Top Page Image Contents