KitchenAid 12828134, 2300262 manual Base Grille, RefrigeratorDoor

Page 7

Base Grille

Remove the Base Grille

1.Grasp the grille with both hands.

2.Pull the grille toward you.

Replace the Base Grille

1.See the markings on the inside of the base grille for proper placement.

2.Align the grille mounting clips with the cabinet slots.

3.Push the grille firmly into the cabinet slots until it snaps into place.

RefrigeratorDoor

Graphics are included later in this section.

Remove and Replace Handles (Architect® Series)

1.Using a ³⁄₃₂" Allen wrench, loosen the two set screws located on the side of each handle. See Graphics 2 and 4.

2.Pull the handle straight out from the door. Make sure you keep the screws for reattaching handles.

3.To replace the handle, reverse the directions.

Remove Handles (Panel Series)

IMPORTANT:

■Remove the door from refrigerator before removing handles.

■You must remove the handles to remove the decorator panels or to reverse the door swing.

1.Using a Phillips screwdriver, remove the top door cap. See Graphic 3.

2.Tap the bottom edge of the refrigerator door handle upward with a rubber mallet.

3.Handle will slide up approximately ³⁄₄" (19.05 mm) and release from the door.

Replace Handles (Panel Series)

1.Make sure the bottom door cap is installed. See Graphic 5.

2.Align handle notches with metal mounting tabs on the side of the door. Slide the handle down until it locks.

3.Tap the top of the handle with a rubber mallet to ensure a snug fit.

4.Using a Phillips screwdriver, reinstall the top door cap.

Remove Door and Hinges

IMPORTANT:

■Remove food and any adjustable door bins or utility bins from doors.

■All graphics referenced in the following instructions are included later in this section after “Final Steps.”

⁵⁄₁₆" Hex-Head Top Hinge Screw

TOOLS NEEDED: ⁵⁄₁₆", ³⁄₈", ¹⁄₄" hex-head socket wrench, #2 Phillips screwdriver, and a flat-blade screwdriver.

1.Unplug refrigerator or disconnect power.

2.Keep the refrigerator door closed until you are ready to lift it free from the cabinet.

NOTE: Provide additional support for the refrigerator door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working.

3.Remove the parts for the top hinge as shown in Top Hinge Graphic. Lift the refrigerator door free from the cabinet.

4.Remove the parts for the bottom hinge as shown in the Bottom Hinge Graphic.

Reverse Door (Architect® Series)

IMPORTANT: If you want to reverse your doors so they open from the opposite side, follow these steps. If you are not reversing the doors, see “Replace Door and Hinges.”

Door Stop Screw

Door Handle Seal Screw Front

Flat-Head Handle Screw

Cabinet Hinge Hole Plug

Cabinet

1.Remove the hinge screws from handle side and move them to opposite side. See Graphic 1-1.

2.Using a flat-blade screwdriver tip wrapped in masking tape, remove the cabinet hinge hole plugs from the cabinet top and move them to the opposite side hinge holes as shown in Graphic 1-2.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents BOTTOM-MOUNT Refrigerator Table DES Matières Table of ContentsBefore You Throw Away Your Old Refrigerator or Freezer Refrigerator SafetyLocation Requirements Installation InstructionsClean Before Using Unpack the RefrigeratorWater Pressure Electrical RequirementsWater Supply Requirements Recommended Grounding MethodConnectthe Water Supply Complete the InstallationConnect to Water Line Connect to Refrigerator RefrigeratorDoor Base GrilleRemove Drawer Freezer DrawerReverse Door Panel Series Replace Door and HingesFinal Steps Replace DrawerArchitect Series Door Swing Reversal optionalPanel Series Style 2 Front and rear leveling Adjustthe DoorWater System Preparation Style 1 Front levelingFactory TrimKit 20 cu. ft. Refrigerator door Dimensions for Custom Wood PanelsDimensions for Routing Door Panel Side View Normal SoundsRefrigerator USE Usingthe ControlsEnsuring Proper Air Circulation Holiday Mode Additional Control Center Features Max CoolOptimIce Feature Door AlarmIce Maker Water DispenserWaterFilter Status Light WaterFiltration SystemCrisper and Crisper Cover Refrigerator ShelvesCrisper HumidityControl Temperature-Controlled DrawerFreezer Features Door FeaturesChanging the Light Bulb CleaningTo Clean Your Refrigerator Refrigerator CareIf You Choose to Turn the Refrigerator Off Before You Leave PowerInterruptionsVacation and MovingCare Changing the Freezer Light BulbTroubleshooting Divider between the two compartments is warm Water flow from the dispenser decreases noticeablyWater leaking from the dispenser Dispenser water is not cool enoughU.S.A Assistance or ServiceAccessories CanadaWater Filter Certifications Application Guidelines/Water Supply Parameters Product Data SheetsONE Year Limited Warranty Kitchenaid Refrigerator WarrantyAvant de jeter votre vieux réfrigérateur ou congélateur Sécurité DU RéfrigérateurEnlèvement des matériaux d’emballage Instructions D’INSTALLATIONEmplacement d’installation Déballage du réfrigérateurPression de leau Méthode recommandée de mise à la terreSpécifications électriques Spécifications de l’alimentation en eauRaccordement au réfrigérateur Achever l’installationRaccordementde la canalisation deau Raccordement à une canalisation d’eauPorte du réfrigérateur Grille de la basePorte du réfrigérateur Remplacement de la porte et des charnièresTiroir du congélateur Enlèvement du tiroirÉtapes finales Réinstallation du tiroirSérie Architect Inversion du sens douverture des portes facultatifGarniture de poignée Série avec panneaux décoratifsStyle 2 Nivellement avant et arrière Ajustementde la portePréparation du système d’eau Style 1 Nivellement avantEntretien des panneaux décoratifs Réinstallation du panneau de porteEnsemble décoratif de l’usine Enlèvement du panneau de la portePanneaux en relief Dimensions pour les panneaux en bois personnalisésSons normaux Panneaux unisPour s’assurer d’une circulation d’air Appropriée Utilisation des commandesCommandes de température Utilisation DU RéfrigérateurPour ajuster les réglages de température Ajustement des réglages de commandeHoliday Mode mode vacances Temp Alarm alarme de dépassement de températureDistributeur d’eau Système de filtration d’eau intérieur Témoins lumineux de létat du filtre à eauMachine à glaçons Tablettesdu réfrigérateur Caractéristiques DU RéfrigérateurBac à légumeset couvercle Tiroir à température contrôlée Réglage de l’humidité dansle bac à légumesCaractéristiques DU Congélateur Caractéristiques DE LA PorteNettoyage Pour enlever et réinstaller le compartiment utilitaireEntretien DU Réfrigérateur CompartimentutilitairePannes de courant Remplacement de l’ampoule d’éclairageRemplacement de lampoule du compartiment de réfrigération Remplacement de lampoule du compartiment de congélationLe plat de dégivrage contient de l’eau DépannageDéménagement Les ampoules n’éclairent pasLe distributeur d’eau ne fonctionne pas bien Le réfrigérateur semble faire trop de bruitLa machine à glaçons ne produit pas de glaçons ou pas assez Mauvais goût, odeur ou couleur grise des glaçonsLa température est trop tiède ’eau coule du distributeur’eau du distributeur n’est pas assez froide La cloison entre les deux sections est tièdeAccessoires Assistance OU ServiceSystème de filtration d’eau intérieur Feuilles DE Données SUR LE ProduitGarantie Limitée DE UN AN Garantie DU Réfrigérateur KitchenaidAll rights reserved 12828134

12828134, 2300262 specifications

The KitchenAid 2300262,12828134 stands out as an essential tool for both amateur chefs and seasoned culinary enthusiasts. This versatile appliance combines innovative features with robust design, catering to a wide range of cooking needs.

One of the main features of this model is its powerful motor, which provides consistent and reliable performance. With multiple speed settings, it allows for precise control, whether you’re mixing, kneading, or whipping. This flexibility is perfect for various recipes, from delicate meringues to dense bread doughs.

The 2300262,12828134 incorporates KitchenAid's renowned planetary mixing action, which ensures that all ingredients are thoroughly combined. This technology allows the mixing head to rotate in one direction while the beater rotates in the opposite direction, resulting in efficient and even mixing. This feature saves time and guarantees consistent results in every batch.

Another defining characteristic of this kitchen appliance is its durability. The construction is made from high-quality materials, ensuring longevity and reliability. The robust design withstands the rigors of frequent use, making it a worth investment for any kitchen.

For added convenience, this model features a tilt-head design, which simplifies the process of adding ingredients and cleaning the bowl. The easy-access design means you don’t have to fuss with complicated mechanisms, allowing you to focus on your cooking.

The KitchenAid 2300262,12828134 also comes with a variety of attachments, such as dough hooks and whisks. These attachments enhance the appliance's versatility, enabling it to perform a multitude of tasks. Whether you need to whip cream, mix batter, or knead dough, this model has you covered.

Additionally, compatibility with a range of optional accessories expands its functionality even further. From pasta makers to food grinders, the possibilities are virtually endless, allowing you to experiment with various cooking techniques and recipes.

In summary, the KitchenAid 2300262,12828134 is more than just a mixer; it is a multifunctional appliance designed to elevate your cooking experience. With its powerful performance, innovative technologies, and robust construction, it is a vital addition to any kitchen that values quality and efficiency. Whether you’re preparing everyday meals or gourmet dishes, this KitchenAid model empowers you to achieve your culinary goals with ease.
Top Page Image Contents