Complete Preparation
1.Determine the required location for the home power supply cable and drill a ½" (1.3 cm) diameter hole for wire access.
2.Run wire through the home power supply cable according to the National Electrical Code or CSA Standards and local codes and ordinances. There must be enough ½" conduit and wires from the fused disconnect (or circuit breaker) box to make the connection in the hood’s electrical terminal box.
NOTE: Do not reconnect power until installation is complete.
3.Use caulk to seal all openings.
4.For vented installations only: Using a jigsaw or keyhole saw, cut a 6½" (16.5 cm) diameter hole for the vent duct.
5.Attach the upper horizontal support bracket with 4 - 5 x 45 mm wood screws.
A
A. Upper horizontal support
IMPORTANT: All screws must be installed into wood. If there is no wood to screw into, additional wall framing supports may be required.
Assemble and Install Range Hood
1.Install transition on top of hood (if removed for shipping) with 2 - 3.5 x 9.5 mm sheet metal screws.
A
B 
A. Vent transition
B. 3.5 x 9.5 mm screw
2.Position the 4 vertical supports (A) with notches at the bottom and attach to the range hood using 16 - 4 x 8 mm screws.
3.Attach the horizontal support (B) using 8 - 4 x 8 mm screws.
B
A A
A. Vertical supports
B. Horizontal support
4.Attach a second set of vertical supports (A) and set the vertical height (B). See “Installation Dimensions” in the “Location Requirements” section to help determine the desired dimension for the vertical height “B.”
A A
B
A. Vertical supports
B. Vertical height
5.Using 2 or more people, lift the range hood assembly and attach it by snapping the vertical supports to the spring clips in the upper horizontal support bracket that is mounted to the ceiling.
6.Install 16 - 4 x 8 mm screws and tighten to secure.
A
A. Mounting screws
Connect Vent System
1.Install vent system.
2.Push duct over the exhaust outlet. Seal all connections with vent clamps.
7