Hotpoint UD47, UT47 manual If something goes wrong, Problem Check

If something goes wrong...

Before calling a Service Engineer, please check through the following lists.

	THERE MAY BE NOTHING WRONG.
Problem		Check
Nothing works.		(a) Check
		If you find :-
		Display is blank.
		Then it is likely that there is no electricity supply to your oven.
		Check: (i) That the main cooker wall switch is turned on.
		(ii) Check other appliances to see if you have a power cut.
		(iii) Check the main circuit breaker for the property.
Display shows 0.00 AUTO.		The power supply to your oven has possibly been interrupted, but has
		now come back on again. Reset the timer to the correct time of day and
		"Manual" operation using instructions given in the timer section of the
		book.
Main & Top Ovens do not work,		Check the following to ensure that the timer is in Manual Mode:
but the Grill works.		Check that the Auto Symbol is not lit up and is not flashing.
		See timer section for instructions on how to return timer to
		"Manual".
Top Ovens and Grill do not work,		Operating the cooker under the following conditions may cause a safety
but the Main Oven works.		device to operate.
		(a) Grilling with the door closed - always grill with the door open
		to the correct position - see grilling.
		(b) Grilling for an excessively long period at maximum setting -
		see grilling guide.
		(c) Grilling with inadequate ventilation in the cabinet - see
		installation instructions.
Grill does not work.		Check that you have selected :- "Grill" function on the "Top/Oven Grill
		Select" knob (B) and a Grill setting on the "Grill" knob (A) - see grilling
		page.
Grill keeps turning on and off.		When the "Grill" control (A) is operating at less than MAX, the grill will
		cycle on and off, this is normal and is not a fault.
Can not set an “Auto Cook”		Remember: "Cook Period" is the actual length of time for which, the timer
programme		will switch the oven(s) on as part of an "Auto Cooking" programme.
Draught from beneath control		A gentle flow of air will be blown from beneath the control panel when
panel.		the appliance is used. If the appliance is still warm, this cooling fan may
		run on, or restart itself after all of the controls have been turned off.
		The fan will stop once the appliance has been cooled.
		This is normal and not a fault.
Timer buzzer/bleeper operates		Press the minute minder button to silence the Buzzer/Bleeper.
continually
If you have been through the above list and there is still a problem, contact Service
	(see KEY CONTACTS, back page).

35