Denon AVC-A1HD, AVP-A1HD owner manual AAuto Setup, Preparation

Auto Setup

Optimize settings for speakers in use.

FMenu tree F

Auto Setup

aAuto Setup s Option

d Parameter Check

aAuto Setup

The settings are performed automatically.

GAuto Setup flowH

STEP1	Preparation	vpage 14, 15
STEP2	Detection & Measurement (main)
		vpage 16, 17
STEP3	Measurement (2nd – 8th)	vpage 18
STEP4	Calculation	vpage 18
STEP5	Check	vpage 19
STEP6	Store	vpage 19
Finish		vpage 20

STEP1 Preparation

•Configure the following settings as required.

•To start Auto Setup without configuring the following settings, perform step 4 only, and then proceed to step 2.

n Amp Assign AVC-A1HD

Select the method for using the power amplifier in accordance with the connected speaker configuration.

Choose this when “Amp Assign” in the GUI menu is set to anything other than “Normal”.

n Pre-out Assign AVP-A1HD

Change the pre-out terminal assignment.

n XLR Out Polarity AVP-A1HD

Set to switch the XLR pre-out terminal polarity.

n Channel Select AVC-A1HD AVP-A1HD

The measurement time can be shortened by selecting the speakers to be measured in advance. Please set if necessary.

When measuring 2 or 3 subwoofers, configure the “Channel Select” settings.

•“Front Height” is displayed when the “Amp Assign” – “Assign Mode” setting (vpage 28) in the GUI menu and the “Extension Channel” setting (vpage 28, 29) are set to “Front Height”.

•“Front Wide” is displayed when the “Amp Assign” – “Assign Mode” setting (vpage 28) in the GUI menu and the “Extension Channel” setting (vpage 28, 29) are set to “Front Wide”.

Getting Started Connections Setup Other Operations Multi-Zone Information Troubleshooting Specifications

14