ENTER
nAdjusting the subwoofer volume level
The optimum subwoofer volume level is 75 dB.
During “Measuring the subwoofer volume level” (vpage 16), an error message is displayed when one level of subwoofers is outside the 72 to 78 dB range.
When using a subwoofer with
3Adjust the subwoofer volume level of your subwoofer so that the level display is within the range of 72 to 78 dB.
AUTO SETUP |
SW Level Matching | 1 2 3 4 5 6 |
Please adjust the level of your active subwoofer unit so that the level indicates approx. 75dB
Getting Started Connections
When 2 or 3 subwoofers are used, adjust the volume level of each subwoofer so that their volume level will set between 72~78 dB.
1Select “SW Level Matching” and then press ENTER.
AUTO SETUP
Caution! | 1 2 3 4 5 6 |
The subwoofer's level is too high or low. Please select "SW Level Matching" and adjust the level of your subwoofer unit. If you do not want to use the
subwoofer, select "Skip".
Stop
99.8dB
Enter
Change from red to blue when level matches
b If the measured level is outside the 72 to 78 dB range, the level indicator is red.
b When measuring stops, press ENTER.
AUTO SETUP |
SW Level Matching | 1 2 3 4 5 6 |
Please adjust the level of your active subwoofer unit so that the level indicates approx. 75dB
Setup Other Operations Multi
ENTER
ENTER
| SW Level Matching |
| Stop | |
| Skip |
| ||
| Enter | RETURN Cancel | 75.5dB | |
| Proceed to subwoofer volume adjustment item |
|
| |
2 |
|
| Enter | |
Select “SW Test Start” and then press ENTER. | Change from red to blue when level matches | |||
| ||||
Measure the subwoofer volume level. |
| b If the measured level is within the 72 to 78 dB range, the level | ||
During measuring, a “Testing…” message is displayed. | ||||
| indicator is blue. | |||
| When measurements are completed, the measurement level |
| ||
| value is displayed. |
| When the measured level is within the 72 to 78 dB | |
| AUTO SETUP |
| 4range, press ENTER. | |
| 1 2 3 4 5 6 |
|
|
|
SW Level Matching |
| 5 | Select “Next” and then press ENTER. | |
|
| |||
Please place the microphone at ear height at main |
| |||
listening position, then push ENTER. |
|
|
| Proceed to step 2 of “STEP2 Detection & Measurement |
|
|
|
| |
(main)“(vpage 16).
SW Test Start
(Main remote control unit) | (Sub remote control unit) |
dB
Next
Enter | RETURN Cancel |
Start measurement. Output test tone from subwoofer
AUTO SETUP |
SW Level Matching | 1 2 3 4 5 6 |
After adjustment, push "Next". |
|
SW Test Start |
|
dB |
|
Next |
|
Enter | RETURN Cancel |
Proceed to next measurement |
|
17