Denon AVC-A1HD Setting with Respect to the Zone, Setting with Respect to the Input Source

hTrigger Out 1	AVC-A1HD
kTrigger Out 1	AVP-A1HD

Select the conditions to turn on the trigger out 1 with respect to the zone, input source, surround mode, HDMI monitor, etc.

For details about the trigger out function, see mpage 22.

jTrigger Out 2	AVC-A1HD
lTrigger Out 2	AVP-A1HD

This sets the conditions to turn on the trigger out 2, in the same way as “Trigger Out 1” above.

kTrigger Out 3	AVC-A1HD
A0Trigger Out 3	AVP-A1HD

This sets the conditions to turn on the trigger out 3, in the same way as “Trigger Out 1” above.

lTrigger Out 4	AVC-A1HD
A1Trigger Out 4	AVP-A1HD

This sets the conditions to turn on the trigger out 4, in the same way as “Trigger Out 1” above.

[Selectable items] ON – – –

Setting with Respect to the Zone

When the power of the zone turned on/off, the trigger out turns on.

Setting with Respect to the Input Source

When the input source set to on is selected, the trigger out turns on.

Associated with respect to the input source for zones set to “ON” at “Setting with Respect to the Zone”.

Setting with Respect to the Surround Mode

When the surround mode set to on is selected, the trigger out turns on.

This is effective when the “MAIN ZONE” has been set to “ON” for the “Setting with Respect to the Zone” and the input source which is set to “ON” has been selected for the “Setting with Respect to the Input Source”.

Setting with Respect to the Monitor

When the HDMI monitor set to on is selected, the trigger out turns on.

This is effective when the “MAIN ZONE” has been set to “ON” for the “Setting with Respect to the Zone” and the input source which is set to “ON” has been selected for the “Setting with Respect to the Input Source”.

A0Transducer Setup	AVC-A1HD
A2Transducer Setup	AVP-A1HD
Settings when using transducer.

The Transducer Setup can be accessed through GUI menu “Speaker Setup” – “Subwoofer Setup” is “1SP”, “2SP L/R” or “2SP MIX”. The transducer signal is outputted from “SW3”.

Level [Variable range]

–12dB~ 0dB ~ +12dB : Set the transducer level. OFF : Turn the transducer output off.

When you adjust “Level”, the adjusted value is set for all surround modes.To adjust the level for individual surround modes, use “Channel

Level” (vmpage 65 AVC-A1HD , mpage 67 AVP-A1HD).

LPF

Set the upper limit of the low frequency output to the transducer.

[Selectable items]

40Hz	60Hz	80Hz	90Hz	100Hz	110Hz	120Hz
150Hz	200Hz	250Hz

Getting Started Connections Setup Other Operations Multi-Zone Information Troubleshooting Specifications

32