840155501 ENv01.qxd 2/26/08 1:43 PM Page 7
Optional Cleaning
1.Remove dispenser assembly cap by rotating coun- terclockwise.
3.Reassemble plunger inside of dis- penser body and rotate cap clockwise until tight.
Dispenser
Assembly
Cap
Plunger 
Adaptor
2.Wash dispenser and parts in hot, soapy water. Rinse and dry thoroughly. Do not soak.
NOTE: Do not remove seal rings from adaptor.
Dispenser |
|
Assembly |
|
Body | Seal Rings |
|
Troubleshooting
PROBLEM | PROBABLE CAUSE/SOLUTION | |
|
|
|
Blender leaks. | • | Tighten cutting assembly on jar. |
| • | Make sure gasket is in place on cutting assembly. |
| • | Make sure gasket is not damaged. If damaged, please |
|
| call our |
|
| replacement. |
| • | Make sure lid with filler cap is pushed down tightly on |
|
| jar. |
Ice not crushed. | • | See ice crushing instructions in “Blending Specific |
|
| Foods” section. |
|
|
|
Does not | • | Make sure enough liquid has been added. A |
blend well. |
| minimum of 10 ounces (300 ml) is recommended. |
Does not dispense. | • | Make sure blender is ON. |
|
|
|
Dispenser leaks. | • | Make sure seal rings are in place on dispenser |
|
| adapter. |
| • | Tighten dispenser cap (located above dispenser body). |
Cannot remove | • | Loosen collar by holding jar and turning cutting |
cutting assembly. |
| assembly counterclockwise. |
|
|
|
7