BURNERS
They can be removed and washed only with soapy water. Detergents can be used but must not be abrasive or corrosive.
Do not use abrasive sponges or pads. Do not put in dishwasher.
After each cleaning, make sure that the
It is essential to check that the burner flame distributor F and the cap C has been correctly positioned (see fig. 29) - failure to do so can cause serious problems.
Check that the electrode S (fig. 29) is always clean to ensure
Check that the probe T (fig. 29) next to each burner is always clean to ensure correct operation of the safety valves. Both the probe and ignition plug must be very carefully cleaned.
Note:
The electrode S must be very carefully cleaned. To avoid damage to the electric ignition do not use it when the burners are not in place.
TRIPLE RING BURNER
Figure 29
C
F
S
T
The triple ring burner must be correctly positioned (see fig. 30); the burner rib must be located in position as shown by the arrow.
The burner correctly positioned must not rotate (fig. 31). Then position the cap A and the ring B (fig. 31).
Figure 30
32
Figure 31
A B