Lighting GAS Burners

FITTED WITH SAFETY VALVE DEVICE AND ELECTRONIC IGNITION

■Check that the electricity is

switched on to allow spark igni- tion.

■Make sure that all controls are

turned to zero.

■ The gas flow to the burner is controlled by taps with safety cutout device. If the burner flame should go out, the safety cut-off valve will automatically stop the gas flow. The switch for the electric ignition is incorporat- ed in the knobs.

Figure 15

■You control the flow by turning the knob indicator to line up with the following symbols:

– Symbol	● : tap closed (burner off)
– Symbol	: High (maximum)
– Symbol	: Low (minimum)

■ To ignite automatically, push the required knob down and turn it to maximum, keeping the knob down until the burner lights. When the flame is lit, wait for about ten second with the knob down (safety cut-off activation delay).

■ You can control the temperature by the knob to “High” from “minimum”. ■ To switch off, turn the knob clockwise until you hear the safety click.

■ Note that, if you are using a burner at the minimum setting, you turn the knob clockwise past the maximum setting before reaching the off position.

■ Whenever the lighting of the burners is difficult due to peculiar conditions of the gas features or supply, it is advised to repeat the ignition with the knob on “minimum” position.

■ If when lighting any of the burners an abnormal flame appears, switch the burner off and relight using the minimum setting.

■ If the flame is still not correct, turn the burner off and call our Customer Service center for your nearest Authorized Delonghi Service Agent.

■ In the case of a mains failure light the burner with a match or lighted taper.