Hobart FT900SDBD, FT900SBD, FT900DBD, FT900BD manual Cleaning

Page 7

CLEANING

The dishwasher MUST be thoroughly cleaned at the end of each working shift or after each meal. Push the Power key on the keypad to turn the machine OFF.

Disconnect electrical power supply(ies) and follow lockout / tagout procedures before you begin cleaning.

Open all front access doors. Drain the machine by rotating the drain handles counterclockwise to a horizontal position. Drain handles are located near the floor at the front of each tank. On Dual Rinse machines (FT900D or FT900SD) the dual rinse tank drain handle is located to the side of the control box on the unload end of the machine. Draining the tanks requires approximately 5 to 10 minutes.

Remove and clean the curtains. Before removing strainer baskets and pans, clean the interior and all tank shelves using a good hose with spray nozzle (Figs. 13 – 15). Flush all debris toward the strainers.

Fig. 13

Fig. 14

Fig. 15

Remove the wash arms by first releasing the latches (Fig. 16). Slide upper arms forward, swinging front of arm down (Fig. 17). Slide lower arms forward, tilt front of arms upward to allow water to drain. Remove arms. Remove end caps (Fig. 18). Clean wash arms in a sink.

Fig. 16

Fig. 17

Fig. 18

Remove the flush arm at the load end of the machine (Fig. 19). Remove end cap. Clean flush arm and nozzles in sink. Remove the strainer baskets (Fig. 20) and strainer pans (Fig. 21). Also remove the dual rinse strainer if present. Empty strainers in trash receptacle or food waste disposer. DO NOT

STRIKE STRAINER PANS OR STRAINER BASKETS ON SOLID OBJECT TO DISLODGE DEBRIS. Scrub

strainer pans and strainer baskets in a sink.

Fig. 19

Fig. 20

Fig. 21

 

 

 

– 7 –

Image 7
Contents FT900 Series Dishwashers Table of Contents Machine Preparation Check before beginning operation FT900 Series Dishwashers OperationTank Filling Dishwashing Alternative Temperature Display Names Table aUnloading Recommended Minimum TemperaturesEmpty Strainer Baskets During Operation AS Necessary LoadingCleaning Clean Sensor Openings AT Load END of Machine Cleaning the TOP Duct DOs and DONTs for Your NEW Hobart Dishwasher Cleaning the BLOWER-DRYER AIR FilterLoad Curtains and Drainback PANS, Model FT900To L Operation Center Section Curtains and Drainback PANS, Model FT900DTo L Operation 4 Center Section Curtains and Drainback PANS, Model FT900SFT900SD To L Operation 4 Center Section Curtains and Drainback PANS, Model FT900SDManager M Machine Operation and Programming Security LevelsOperator O SuperOperator SOMenu Display Prompts User Programming InstructionsNavigating the Parameters Menu Entering the Parameters MenuParameters Menu Table Parameters MenuCommunications Setup Menu Table Communications Setup MenuConveyor Gearmotor Line StrainersLubrication MotorsConveyor Take-Up Unit Conveyor Speed AdjustmentConveyor Drive Chain Conveyor Shaft Flange BearingsDisconnect electrical power supplyies and follow Symptom Possible CauseElectronic Sensor AT Load END Hobart Service Display Reads Possible Resolution Page Page Date