Hobart FT900D, FT900SDBD, FT900SBD, FT900BD Line Strainers, Lubrication, Motors, Conveyor Gearmotor

Page 20

MAINTENANCE

Disconnect electrical power supply(ies) and follow lockout / tagout procedures before performing any maintenance procedure.

LINE STRAINERS

Line strainers used in water or steam lines should be cleaned one week after machine installation and periodically thereafter.

LUBRICATION

A list of acceptable lubricants, as well as the lubricants themselves, are available from your local Hobart Service Office.

Motors

All motors have sealed bearings and require no lubrication maintenance.

Conveyor Gearmotor

Check the oil level in the conveyor gearmotor at the unload end of the machine every six months by removing the gear case fill-plug (Fig. 36). The oil level should be at the bottom of the fill-plug hole. Draining the gear case can be achieved by removing the Drain Plug (Fig. 36) and capturing and recycling the drained oil. After rescrewing the Drain Plug back in the hole, use only Mobilgear # 630 to replenish or replace the oil.

GEAR CASE

FILL PLUG

DRAIN PLUG

Fig. 36

– 20 –

Image 20
Contents FT900 Series Dishwashers Table of Contents FT900 Series Dishwashers Operation Machine Preparation Check before beginning operationTank Filling Alternative Temperature Display Names Table a DishwashingRecommended Minimum Temperatures Empty Strainer Baskets During Operation AS NecessaryLoading UnloadingCleaning Clean Sensor Openings AT Load END of Machine Cleaning the TOP Duct Cleaning the BLOWER-DRYER AIR Filter DOs and DONTs for Your NEW Hobart DishwasherCurtains and Drainback PANS, Model FT900 LoadCurtains and Drainback PANS, Model FT900D To L Operation Center SectionCurtains and Drainback PANS, Model FT900S To L Operation 4 Center SectionCurtains and Drainback PANS, Model FT900SD FT900SD To L Operation 4 Center SectionMachine Operation and Programming Security Levels Operator OSuperOperator SO Manager MUser Programming Instructions Menu Display PromptsEntering the Parameters Menu Navigating the Parameters MenuParameters Menu Parameters Menu TableCommunications Setup Menu Communications Setup Menu TableLine Strainers LubricationMotors Conveyor GearmotorConveyor Speed Adjustment Conveyor Drive ChainConveyor Shaft Flange Bearings Conveyor Take-Up UnitSymptom Possible Cause Disconnect electrical power supplyies and followElectronic Sensor AT Load END Hobart Service Display Reads Possible Resolution Page Page Date