Frymaster YFPRE1817E operation manual Do not block the area around the base or under the fryers

Page 9

DANGER

This appliance must be connected to a power supply having the same voltage and phase as specified on the rating plate located on the inside of the appliance door.

DANGER

All wiring connections for this appliance must be made in accordance with the wiring diagram(s) furnished with the appliance. Refer to the wiring diagram(s) affixed to the inside of the appliance door when installing or servicing this equipment.

DANGER

Frymaster appliances equipped with legs are for stationary installations. Appliances fitted with legs must be lifted during movement to avoid damage to the appliance and bodily injury. For movable installations, optional equipment casters must be used. Questions? Call 1-800-551-8633.

DANGER

Do not attach an apron drainboard to a single fryer. The fryer may become unstable, tip over and cause injury. The appliance area must be kept free and clear of combustible material at all times.

In the event of a power failure, the fryer(s) will automatically shut down. If this occurs, turn the power switch OFF. Do not attempt to start the fryer(s) until power is restored.

This appliance must be kept free and clear of combustible material, except that it may be installed on combustible floors.

A clearance of 6 inches (15cm) must be provided at both sides and back adjacent to combustible construction. A minimum of 24 inches (61cm) should be provided at the front of the equipment for servicing and proper operation.

WARNING

Do not block the area around the base or under the fryers.

DANGER

Prior to movement, testing, maintenance and any repair on your Frymaster fryer, disconnect all electrical power from the fryer.

2.1.2 Electrical Grounding Requirements

All electrically operated appliances must be grounded in accordance with all applicable national and local codes, and, where applicable, CE codes. A wiring diagram is located on the inside of the fryer door. Refer to the rating plate on the inside of the fryer door for proper voltages.

2.1.3 Australian Requirements

To be installed in accordance with AS 5601 / AG 601, local authority, gas, electricity, and any other relevant statutory regulations.

2-2

Image 9
Contents YFPRE1817E Hour Service HotlineCanada Page Table of Contents YFPRE18E Electric Fryers Introduction Safety InformationGeneral Computer InformationDefinitions Installation, Operating, and Service PersonnelService Information Shipping Damage Claim ProcedureYFPRE18E Electric Fryer Installation Instructions Do not block the area around the base or under the fryers Electrical Grounding RequirementsAustralian Requirements Three 3 Phase Requirements Power RequirementsPage Finding Your WAY around the YFPRE18E Electric Fryer YFPRE18E Electric Fryer Operating InstructionsEquipment Setup and Shutdown Procedures SetupShutdown Controllers Page YFPRE18E Electric Fryer BUILT-IN Filtration General Filtration PreparationAssembling the Filter Crumb screen to rest on the top edges Daily Filtration Operation Installing the FilterFiltering Tools Operating the FilterPrior to filtering, skim any large debris from oil in frypot Filter Operation YFPRE18E Electric Fryer BUILT-IN Filtration YFPRE18E Electric Fryer Preventative Maintenance Fryer Page Introduction YFPRE18E Electric Fryer Operator TroubleshootingTroubleshooting Controller and Heating Problems Problem Probable Causes Corrective ActionController wont ActivateFiltration Problems Problem Probable CausesFilter pump wont StartBut oil does not Filter pump runsReturn to frypot There is no bubblingThis page Intentionally Left Blank Service Hotline