SERVICE (cont.)
COOLING DRUM ALIGNMENT
Ledge
Boss
Legs
FIG. 23 COOLING DRUM SHIPPING SUPPORT
The “A” shaped Cooling Drum Shipping Supports, removed during Initial
Symptoms:
Squeaky Operation, hopper lifts or won’t seat properly, hopper is pushed to one side or the other.
To check alignment
1.Place the “A” shaped support on the auger shaft with the ledge under the cooling drum.
2.Lift the cooling drum while rotating the support into a vertical position. The boss on the very bottom will drop into the hopper drip tray’s drain hole.
FIG. 24 CHECKING ALIGNMENT | P1510 |
|
When in its proper position, the cooling drum will cause a slight pressure on the hopper drip tray drain hole and the two legs will be equidistant from the hopper drip tray.
If adjustment is needed, remove the support and gently force the free end of the evaporator in the direction the adjustment is needed.
Reinstall the support, check the alignment, and read- just the cooling drums as required.
35 | 27646 122200 |
|