Bunn CDS-3 service manual Operating Controls

OPERATING CONTROLS

(CDS-3 Controls Illustrated)
ICE CONTROLS	ICE/OFF/NO-ICE SWITCHES
Controls the consistency of the ice in the hoppers	ICE – This is the normal operating position. Freezes
when the DAY/NIGHT switch is in the left “DAY” and maintains the ice in the selected hopper to the
position and the ICE/OFF/NO-ICE switch is in the left	consistency set with the ICE control(s) when in the left
“ICE” position.	“ICE” position.
Turn this control clockwise to produce a		OFF – Provides no cooling to the selected hop-
coarser ice or counterclockwise to produce		per when in the center “OFF” position.
a finer ice. (The dispenser is set to deliver		NO-ICE – Maintains cooling yet allows any ice
satisfactory ice at a 1:00 setting.)		in the selected hopper to naturally thaw when
AUGER SWITCHES		in the right “NO-ICE” position.
		DAY/NIGHT SWITCH
­”—” – This is the normal operating posi-
tion. Energizes the auger motor when in		DAY – This is the normal operating position.
the right position. The dispenser will cool		The hoppers’ display lights will glow and the
to the ice consistency or liquid temperature		electronic controls will maintain ice when the
presets only with the switch in the right		switch is in the left “DAY” position, the indi-
position.		vidual hoppers’ ICE/OFF/NO-ICE switches are
“o” – Removes power from the auger mo-		in the left “ICE” position, and the individual
tor when in the left position.		hoppers’ AUGER switches are in the right “—”
		position.
POWER OFF/ON SWITCH		NIGHT – Use this position at night. The hop-
ON – This is the normal operating position. The dis-		pers’ display lights will be out yet the liquid
	will be kept cold in all hoppers when this switch is in the
penser is electrically energized when the switch is in
	right “NIGHT” position and the AUGER switches are in
the right “ON” position. NOTE – The compressor will
	the right “—”position.
start after a 3 minute 20 second delay on the CDS-2
and a 6 minute 30 second delay on the CDS-3.	NOTE: When Day/Night Timer is used, the Day/Night
OFF – All electrical components of the dispenser are
	Switch in the control drawer must be kept in the “DAY”
without power when the switch is in the left “OFF”
	position.
position.
	POWER INDICATOR (Located on the front of the
	drawer)
	Glows to show that the POWER OFF/ON Switch is in the
	right “ON” position.

STATUS INDICATORS

The electronic controls continuously diagnose the operational status of the dispenser and indicate as listed:

FLASHING 50% ON / 50% OFF – Glows while preparing for coolant to flow to the selected hopper. (Flashes for 10-seconds, then glows steady for two minutes.)

STEADY GLOW – Glows for two minutes before coolant flows to the selected hopper, then continues to glow while coolant flows.

The electronics also sense and indicate error conditions in the dispenser as listed:

ONE FLASH EVERY FOUR SECONDS – Cooling is needed by the selected hopper, but the auger isn’t turning. Try placing the AUGER switch for the selected hopper in the right “—” position.

8 27646 022500