BREW VALVE (EARLY MODELS) AND BYPASS VALVE ON ALL ICB's
FIG. 13-1 EARLY BREW VALVE
Location:
The brew valve is located inside the top cover behind the front face plate.
Test Procedures:
1.Refer to the Programing Section for Service Tools/ Test Outputs/Brew Valve.
2.Be sure brew funnel & server are in place before activating valve.
3.Check the valve for coil action. Turn on the valve with the test mode. Listen carefully in the vicinity of the brew valve for a click as the coil pulls the plunger in.
If no sound is heard as described, proceed to #4.
If the sound is heard as described, there may be a blockage in the valve , hose, tank, or sprayhead. Disconnect the brewer from the power source. Remove the valve and inspect for blockage, and
4.Connect the voltmeter leads to the coil terminals. Turn on the valve with the test mode.
The indication will be
If voltage is present as described, but no coil action is
observed, brew valve is defective. Replace valve and test again to verify repair.
If voltage is not present as described, refer to Wir- ing Diagrams and check the brewer wiring harness. Also check the control board and switch for proper operation.
Removal and Replacement:
1.Disconnect the brewer from the power source.
2.Disconnect wires from the valve.
3.Drain enough water from the tank so the water level is below the outlet.
4.Remove hoses from the valve.
5.Remove the two
6.Install new valve using the two
7.Reconnect hoses to the valve and secure in place with clamps.
FIG. 13-2 EXPLODED VIEW
Due to the internally rectified coil, do not attempt to test this type of coil with an ohm- meter. The reading will be open or very high resistance, depending on the polarity of your meter leads.
13 | 42461 0911809 |
|