VOLTAGE SELECTOR SWITCH
FIG. 21-1 VOLTAGE SELECTOR SWITCH
Location:
The voltage selector switch is located on the component mounting bracket on the base plate.
Test Procedure:
1.Disconnect the brewer from the power source.
2.Disconnect the wires from the selector switch. With the selector switch in the 120V position, check for continuity between the two right terminals of the switch.
3.With the selector switch in the
If continuity is not present as described, replace the switch.
Removal and Replacement:
1.Disconnect the brewer from the power source.
2.Disconnect the three wires from the selector switch.
3.Remove the switch mounting nut from the under side of component mounting bracket; remove switch from bracket.
4.Install new switch in component mounting bracket and secure with mounting nut.
FIG. 21-2 VOLTAGE SELECTOR
SWITCH TERMINALS
21 | 42461 0911809 |
|