POWER SWITCH
FIG. 22-1 POWER SWITCH (ICB SHOWN)
Location:
The power switch is located on the lower right side of the trunk (ICB) or lower rear panel (ITCB).
Test Procedure:
Removal and Replacement:
1.Disconnect the brewer from the power source.
2.Disconnect the wires from the power switch.
3.Remove the switch mounting screws from the left side of trunk.
4.Install new switch in trunk with the two
L1
L2
FIG. 22-2 ROCKER SWITCH
1.Disconnect the brewer from the power source.
2.Disconnect the wires from the power switch. With the switch in the ON position, check for continuity between the upper and lower terminals on each side of the switch.
There should be continuity between the two left ter-
minals and between the two right terminals when ON,FIG.
If continuity is not present as described, replace the switch.
22 | 42461 0911809 |
|