Belshaw Brothers EZ24, EZ34, EZ18 manual The Pump Motor Will Not Run, Possible Causes, What To Do

THE SHORTENING DOES NOT FLOW FREELY THROUGH THE FILTER SYSTEM

Possible Causes		What To Do
The hose is crimped.		Straighten the hose.
		WARNING
		To avoid being burned, before doing any of the
		following, turn off the EZ Melt and allow the
		shortening to cool.
The hose is clogged with shortening.		Soak the hose in warm water to help release the
	clogged shortening. Hang it up and let it dry
	before you use it again.
The drain tube is clogged with solid shortening.	Remove the drain tube and soak it in warm water
	to help release the clogged shortening.
The pickup tube is clogged with residue.	Remove the pickup tube and clean it.
THE PUMP MOTOR WILL NOT RUN
Possible Causes		What To Do
The connection of the power cord to the power	Make sure the power cord is fully plugged in to a
source is faulty.	proper power source.
The circuit breaker has been tripped.		Press the reset button.
	If the problem persists, consult your Belshaw
	dealer, or call Belshaw.

Belshaw Bros., Inc. š 1750 22nd Ave. S. š Seattle, WA 98144 š Phone 206-322-5474 š Fax 206-322- 5425

EZ Melt Model EZ18, EZ24, EZ34 MN-1316EN 13