Belshaw Brothers EZ24, EZ34, EZ18 manual To avoid electrocuting yourself or damaging

Page 12
To avoid electrocuting yourself or damaging

Thoroughly clean your EZ Melt before using it. Refer to Section 3, “Cleaning,” for cleaning instructions.

WARNING

Moisture causes hot shortening to spatter, which may cause serious injury. Thoroughly dry the kettle and any other parts you wash.

WARNING

To avoid electrocuting yourself or damaging

the EZ Melt, never allow water, steam,

cleaning solution, or other liquid to enter the

heater head.

Make sure that the power requirements of the EZ Melt, shown on the data plate, match your power source.

Belshaw Bros., Inc. š 1750 22nd Ave. S. š Seattle, WA 98144 š Phone 206-322-5474 š Fax 206-322- 5425

4

MN-1316EN

EZ Melt Model EZ18, EZ24, EZ34

Image 12
Contents Models EZ18, EZ24, AND EZ34 Operator’s Manual EZ MeltFill and Filter Page EQUIPMENT RECORD Page Contents InstallationCleaning TroubleshootingFigures Preface Page 1Installation filter assemblyhandle heater headhose connector Reset button Heat switch with pilot light Pump switch with pilot lightFigure 1-4.Heater head Bleeder Pickup tube Heating element kettleTo avoid electrocuting yourself or damaging 2Operation Melting and Filling7.Turn the pump on using the PUMP switch Filtering a.Allow the filter assembly to cool to the touch d.Put the filter assembly back on the EZ Melt Cleaning3 Do not touch the heating element! It is very Troubleshooting4 THE PUMP MOTOR WILL NOT RUN Possible CausesWhat To Do This page has been left blank intentionally Parts Lists BILL OF MATERIAL DESCRIPTIONFASTENERS ITEM QTY. DESCRIPTIONFIGURE 5-1 EZ18-2000SHORTENING MELTER ASSEMBLY MN-1316EN FIGURE 5-2 EZ18-2001SHORTENING MELTER ASSEMBLY MN-1316EN FIGURE 5-3 EZ24-2000SHORTENING MELTER ASSEMBLY MN-1316EN FIGURE 5-4 EZ24-2001SHORTENING MELTER ASSEMBLY MN-1316EN FIGURE 5-5 EZ34-2000SHORTENING MELTER ASSEMBLY MN-1316EN FIGURE 5-6 EZ34-2001SHORTENING MELTER ASSEMBLY FIGURE 5-7 EZ24/34-1000HEATER HEAD ASSEMBLY PARTS LIST 5-7 EZ24/34-1000HEATER HEAD ASSEMBLY Wiring Diagrams EZ18-4002120V, 50/60 Hz, 1 PhEZ18-4003208/240V, 50/60 Hz, 1 Ph EZ Melt Model EZ18, EZ24, EZ34 MN-1316ENMN-1316EN EZ Melt Model EZ18, EZ24, EZ34