Belshaw Brothers EZ34, EZ24, EZ18 manual Do not touch the heating element! It is very

Page 19
Do not touch the heating element! It is very

WARNING

Do not touch the heating element! It is very

hot and will burn you.

11.Remove the kettle from the frame. You must remove it from the rear.

12.Pour any shortening remaining in the kettle into a metal container. If it is too heavy or awkward for you to lift by yourself, get someone to help you.

WARNING

Thoroughly clean and dry the floor if shortening, water, or other materials are spilled. Materials spilled on the floor may cause serious injury and loss of life.

13.Scrape out any residue and discard it.

14.Wash the kettle, the cube melter, and the filter frame with warm, soapy water.

15.Dry all the parts completely. The kettle and all other parts must be completely dry before you use the EZ Melt again.

WARNING

Moisture on parts causes hot shortening to spatter, which may cause serious injury.

16. Re-assemble the EZ Melt.

Belshaw Bros., Inc. š 1750 22nd Ave. S. š Seattle, WA 98144 š Phone 206-322-5474 š Fax 206-322- 5425

EZ Melt Model EZ18, EZ24, EZ34

MN-1316EN

11

Image 19
Contents EZ Melt Models EZ18, EZ24, AND EZ34 Operator’s ManualFill and Filter Page EQUIPMENT RECORD Page Troubleshooting ContentsInstallation CleaningFigures Preface Page heater head 1Installationfilter assembly handlehose connector Heating element kettle Reset button Heat switch with pilot lightPump switch with pilot light Figure 1-4.Heater head Bleeder Pickup tubeTo avoid electrocuting yourself or damaging Melting and Filling 2Operation7.Turn the pump on using the PUMP switch Filtering a.Allow the filter assembly to cool to the touch d.Put the filter assembly back on the EZ Melt Cleaning3 Do not touch the heating element! It is very Troubleshooting4 Possible Causes THE PUMP MOTOR WILL NOT RUNWhat To Do This page has been left blank intentionally Parts Lists ITEM QTY. DESCRIPTION BILL OF MATERIALDESCRIPTION FASTENERSFIGURE 5-1 EZ18-2000SHORTENING MELTER ASSEMBLY DESCRIPTION FIGURE 5-2 EZ18-2001SHORTENING MELTER ASSEMBLY DESCRIPTION FIGURE 5-3 EZ24-2000SHORTENING MELTER ASSEMBLY DESCRIPTION FIGURE 5-4 EZ24-2001SHORTENING MELTER ASSEMBLY DESCRIPTION FIGURE 5-5 EZ34-2000SHORTENING MELTER ASSEMBLY DESCRIPTION FIGURE 5-6 EZ34-2001SHORTENING MELTER ASSEMBLY FIGURE 5-7 EZ24/34-1000HEATER HEAD ASSEMBLY PARTS LIST 5-7 EZ24/34-1000HEATER HEAD ASSEMBLY EZ18-4002120V, 50/60 Hz, 1 Ph Wiring DiagramsEZ18-4003208/240V, 50/60 Hz, 1 Ph MN-1316EN EZ Melt Model EZ18, EZ24, EZ34EZ Melt Model EZ18, EZ24, EZ34 MN-1316EN