Hoshizaki KMS-1400MLH instruction manual Startup

Page 23

I. Startup

IMPORTANT

1.Electrical power must be on at the condensing unit for a minimum of 4 hours prior to startup to prevent compressor damage.

2.All parts are factory-adjusted. Improper adjustments may result in failure.

3.If the unit is turned off, wait for at least three minutes before restarting the icemaker to prevent damage to the compressor.

4.Do not operate the unit in the "WASH" position without water in the water tank. This will cause damage to the water pump seal.

1)Open the water supply line shut-off valve.

2)Remove the front panel.

3)Move the control switch on the control box to the "ICE" position.

4)Replace the front panel in its correct position.

5)Allow the water tank to fill with water and the icemaker to operate for a total of 10 minutes.

6)Move the control switch to the "OFF" position, and drain the water tank by removing the front panel, front insulation panel, front frame, and suction hose. See Fig. 10.

7)Replace the removed parts in their correct positions.

8)Clean the dispenser unit/storage bin using a neutral cleaner. Rinse thoroughly after cleaning.

9)Move the control switch to the "ICE" position to start the automatic icemaking process.

10)Replace the front panel in its correct position.

Suction Hose

Front Frame

Thumbscrew

Fig. 10

23

Image 23
Contents KMS-1400MLH Hoshizaki AMERICA, INC Contents KMS-1400MLH Specifications Nameplate RatingFor Outdoor USE MOTOR-COMPRESSOR Thermally Protected Condensing Unit Model SRK-14HCondensing Unit Model SRK-14H3 Intentionally Left BlankDimensions/Connections Condensing Unit Model SRK-14H/3 Icemaker II. Installation and Operating InstructionsLocation Icemaker Hoshizaki Condensing Unit Condensing UnitChecks Before Installation How to Remove Panels Bin Control Installation Installation of the IcemakerSetup Pump Drain Suction Pipe Hose Thumbscrews Slots Line Set Installation of the Condensing UnitField Fabricated Line Set Installation Factory Line Set InstallationElectrical Connection Electrical Connection Wire Harness Connections Icemaker Water Supply and Drain Connections See FigFinal Checklist Startup Cleaning Procedure III. Cleaning and MaintenanceCleaning and Sanitizing Instructions Page Dispenser Unit/Storage Bin and Scoop MaintenanceSanitizing Procedure Following Cleaning Procedure Stainless Steel ExteriorRemove the water from the potable water supply line See Fig Preparing the Icemaker for Long StoragePage Hoshizaki AMERICA, INC