D. Installation of the Icemaker
CAUTION
1.Power supply and ground wire to the icemaker are supplied from the condensing unit. For details, see section "II.F. Electrical Connection."
2.Before operating the icemaker, the bin control must be installed correctly. Failure to properly install the bin control could result in ice backup and unit damage.
1.Setup
1)If mounting the unit on top of a dispenser unit, follow the dispenser unit's setup procedure. If mounting the unit on top of a storage bin, unpack the storage bin, and attach the 4 adjustable legs provided (bin accessory) to the bottom of the storage bin.
2)Position the dispenser unit/storage bin in the selected permanent location.
3)Place the icemaker on top of the dispenser unit/storage bin and secure.
4)Level the icemaker and dispenser unit/storage bin in both the
2.Bin Control Installation
Follow the instructions below to remove the bin control from the shipping area and install the bin control.
1) Remove the front frame: Remove the two thumbscrews and lift off.
Bin Control | 1 |
13