H. Final Checklist
1)Is the icemaker level?
2)Are all components, fasteners, and thumbscrews securely in place?
3)Is there at least 24" (61 cm) minimum clearance around the condensing unit?
4)Have the shipping carton, tape, and packing material been removed from the icemaker and condensing unit? Are the cube guides and tank separator in their correct positions?
5)Is the icemaker in a site where the ambient temperature is within +45°F to +100°F (7°C to 38°C) all year around?
6)Have all electrical, water, and refrigerant connections been made? Are line sets tightened, secured, and free of kinks?
7)Does the electrical installation meet all national, state, and local codes and regulations? Has the power supply voltage been checked or tested against the nameplate rating? Has a proper ground been installed to the condensing unit and icemaker unit? On three phase model, has the transformer's voltage tap switch been positioned to match incoming voltage? For details, see section "II.F. Electrical Connection."
8)Has the electrical power supply been on to the condensing unit for a minimum of
4 hours?
9)Are the water supply line
Note: The icemaker may stop running when the water supply is off, or if the pressure is below 10 PSIG.
10)Are the compressor
11)Has the bin control been installed and checked for correct operation? To confirm bin control operation, press the bin control's actuator paddle during the first 5 minutes of the freeze cycle. The icemaker should stop within 15 seconds.
12)Were all tank hoses and thumbscrews reconnected and secured after installing the bin control?
Note: Confirm that there is no gap behind the bin control bracket.
13)Has the end user been given the instruction manual, and instructed on how to operate the icemaker and the importance of the recommended periodic maintenance?
14)Has the end user been given the name and telephone number of an authorized service agent?
15)Has the warranty card been filled out and forwarded to the factory for warranty registration?
22