Hoshizaki KMS-1400MLH Maintenance, Sanitizing Procedure Following Cleaning Procedure, Condenser

Page 26

2.Sanitizing Procedure - Following Cleaning Procedure

1)Dilute 2 fl. oz. (60 ml or 4 tbs) of a 5.25% sodium hypochlorite solution (chlorine bleach) with 4 gal. (15 l) of warm water.

2)Remove the insulation panel if it is in its normal position.

3)Pour the sanitizing solution into the water tank.

4)Move the service switch to the "WASH" position.

5)Replace the insulation panel and the front panel in their correct positions.

6)Turn on the power supply to start the sanitizing process.

7)Turn off the power supply after 15 minutes. Remove the front panel.

8)Move the service switch to the "DRAIN" position.

9)Replace the front panel and turn on the power supply for 2 minutes.

10)Turn off the power supply. Remove the front panel.

11)Repeat steps 17 through 29 in "1. Cleaning Procedure" two times to rinse thoroughly.

12)Repeat steps 1 through 11 above one more time.

13)Move the control switch to the "ICE" position.

14)Replace the front panel in its correct position.

15)Clean the dispenser unit/storage bin liner using a neutral cleaner. Rinse thoroughly after cleaning.

16)Turn on the power supply to start the automatic icemaking process.

B. Maintenance

IMPORTANT

This icemaker must be maintained individually, referring to the instruction manual and labels provided with the icemaker.

1. Stainless Steel Exterior

To prevent corrosion, wipe the exterior occasionally with a clean and soft cloth. Use a damp cloth containing a neutral cleaner to wipe off oil or dirt build up.

2.Dispenser Unit/Storage Bin and Scoop

Wash your hands before removing ice. Use the plastic scoop provided (bin accessory).

The dispenser unit/storage bin is for ice use only. Do not store anything else in the dispenser unit/storage bin.

Clean the scoop and the dispenser unit/storage bin liner using a neutral cleaner. Rinse thoroughly after cleaning.

3.Condenser

Check the condenser once a year, and clean if required by using a brush or vacuum cleaner. More frequent cleaning may be required depending on location.

26

Image 26
Contents KMS-1400MLH Hoshizaki AMERICA, INC Contents Specifications Nameplate Rating KMS-1400MLHCondensing Unit Model SRK-14H For Outdoor USE MOTOR-COMPRESSOR Thermally ProtectedIntentionally Left Blank Condensing Unit Model SRK-14H3Dimensions/Connections Condensing Unit Model SRK-14H/3 Icemaker II. Installation and Operating InstructionsLocation Condensing Unit Icemaker Hoshizaki Condensing UnitChecks Before Installation How to Remove Panels Bin Control Installation Installation of the IcemakerSetup Pump Drain Suction Pipe Hose Thumbscrews Slots Installation of the Condensing Unit Line SetFactory Line Set Installation Field Fabricated Line Set InstallationElectrical Connection Electrical Connection Wire Harness Connections Water Supply and Drain Connections See Fig IcemakerFinal Checklist Startup Cleaning Procedure III. Cleaning and MaintenanceCleaning and Sanitizing Instructions Page Stainless Steel Exterior MaintenanceSanitizing Procedure Following Cleaning Procedure Dispenser Unit/Storage Bin and ScoopPreparing the Icemaker for Long Storage Remove the water from the potable water supply line See FigPage Hoshizaki AMERICA, INC