Manitowoc Ice RF Potable Water Requirements, Water Supply and Drain Line SIZING/ Connections

Page 7

Installation Instructions

Section 2

 

 

Water and Drain Requirements

POTABLE WATER REQUIREMENTS

Follow these guidelines to install water inlet lines:

Do not connect the ice machine to a hot water supply. Be sure all hot water restrictors installed for other equipment are working. (Check valves on sink faucets, dishwashers, etc.)

If water pressure exceeds the maximum of 80 psig (552 kPA) recommended pressure, obtain a water pressure regulator from your Manitowoc distributor.

Install a water shut-off valve and union for both the ice making and condenser water lines.

Insulate water inlet lines to prevent condensation.

Plumbing must conform to local codes.

WATER SUPPLY AND DRAIN LINE SIZING/ CONNECTIONS

 

Water Temp

Water

Fitting/Min

Location

Pressure

Tubing

Min/Max

 

Min/Max

Size

 

 

Potable

40°/90°F

14/80 psi

3/8" FPT

Water Inlet

(4°/32°C)

(100/552 kPA)

 

Potable

---

---

1/2" MPT

Water Drain

 

 

 

Condenser

40°/90°F

20/150 psi

3/8” FPT

RF2300 only

Water Inlet

(4°/32°C)

(138/1034 kPA)

 

 

 

= 1/2" FPT

Condenser

---

---

1/2" MPT

Water Drain

 

 

 

Bin Drain

---

---

3/4" FPT

Large Capacity

Bin Drain

---

1" FPT

VENT TUBE

18" (46 CM)

LONG

SEPERATE BIN AND ICE

MACHINE DRAINS ARE

REQUIRED

ROUTE DRAIN TUBING TO

OPEN SITE DRAIN

WATER SHUT-OFF VALVE

REQUIRED - ICE MAKING

WATER INLET TUBING 3/8"

MIN. I.D. (.95 CM)

ICE MAKING

WATER INLET

TUBING 3/8" MIN.

I.D. (.95 CM)

VENT TUBE 18" (46 CM)

LONG

ROUTE

DRAIN

TUBING TO OPEN SITE DRAIN

Typical Water Supply Drain Installation

DRAIN CONNECTIONS

Follow these guidelines when installing drain lines to prevent drain water from flowing back into the ice machine and storage bin:

Drain lines must have a 1.5 inch drop per 5 feet of run (2.5 cm per meter), and must not create traps.

The floor drain must be large enough to accommodate drainage from all drains.

Run separate bin and water-cooled condenser drain lines. Insulate them to prevent condensation.

Vent the bin and ice machine drain to the atmosphere. The ice machine drain requires an 18" (46 cm) vent. Do not vent the condenser drain on water-cooled models.

Drains must have a union or other suitable means to allow in place disconnection from the ice machine when servicing is required.

7

Part Number 000007644 3/11

Image 7
Contents This manual contains English and French text ManitowocTable of Contents Section Customer Support Table of Contents Section MaintenanceTable of Contents Section General Information RF2300 Bin Adapter InstallationModel Numbers Ice Machine Heat of Rejection Section Installation InstructionsInstallation Requirements Location of Ice MachineDrain Connections Typical Water Supply Drain InstallationPotable Water Requirements Water Supply and Drain Line SIZING/ ConnectionsVoltage Section Installation Instructions Electrical ServiceGround Fault Circuit Interrupter Minimum Power Cord SpecificationsRF2300R Quietqube Remote Condensing UnitFactory Equipment Refrigeration Amounts Usage with NON-MANITOWOC Condensing UnitsPotential Personal Injury Situation Line SET Length GeneralRoof/Wall Penetration Route Refrigeration TubingSuction Line OIL Traps Service LoopLengthening or Reducing Line Set Lengths Connect the Line Set to the Ice Machine Head Section Installation Instructions SectionConnecting the line set Connect the Line Set to the Remote Condensing UnitTorque Values Leak Check The Refrigeration SystemOpen The Valves Prior To Starting The Ice Machine Open ValvesInstallation Instructions Section Installation Check List Part Number 000007644 3/11 RF0244/RF0266/RF0385/ RF0388/RF0399/RF0644 Operation Section OperationRFS0650/RF1200/RF2300 Operation Section Operation RFS0300 OperationCleaning/Sanitizing Procedure Section MaintenanceInterior Cleaning and Sanitizing Exterior CleaningProcedure to Clean Heavily Scaled Flake Ice Machines Section MaintenanceICE Chute Removal Maintenance Section Removal of Parts for Cleaning/SanitizingArctic Pure Water Filter System Air-Cooled Condenser CleaningManitowoc Cleaner and Sanitizer ICE Chute Switch Actuator RemovalSection Customer Support ChecklistCustomer Support Limited Warranty What is Covered Customer Support Section Commercial Ice Machine WarrantyWHO is Covered by this Limited WARRANTY? Residential Ice Machine Limited WarrantySection Fonctionnement Section Instructions d’installationTable des matières Section GénéralitésTable des matières suite Section Service clientèlePart Number 000007644 3/11 Section Généralités RF2300 Installation de l’adaptateur de bacRéférences des modèles Machine à glaçons Chaleur de rejet Section Instructions d’installationEmplacement de la machine à glaçons Conditions requises d’installationInstallation d’évacuation d’alimentation en eau type RF1200R/RF2300R Installation de conduitesConditions Requises Pour L’EAU Potable Différentiel Conditions électriques requisesRaccordements D’ÉVACUATION FUSIBLE/DISJONCTEURRoyaume-Uni uniquement Instructions d’installation SectionSituation comportant un risque De blessure corporelle Montants frigorifiques de l’équipement en usineLongueur DES Conduites GénéralitésMontée OU Descente DE Conduites Siphons D’HUILE DE Conduite D’ASPIRATION Boucle de serviceConnecter les conduites au condenseur à distance Étape 4 Raccordement des conduitesValeurs de couple de serrage Ouvrir les robinetsÉtape 8 Exigences d’isolation Page Part Number 000007644 3/11 RF0244/RF0266/RF0385/ RF0388/RF0399/RF0644 Fonctionnement Section FonctionnementRFS0650/RF1200/RF2300 Fonctionnement Fonctionnement Section RFS0300 FonctionnementProcédure de nettoyage et de désinfection EntretienNettoyage et désinfection intérieurs Nettoyage extérieur’eau Uniquement Nettoyant Eau Entretien SectionDépose DE LA Goulotte À Glaçons Dépose DE L’ACTIONNEUR D’INTERRUPTEUR DE Goulotte À Glaçons Nettoyage du condenseur refroidi à l’airSystème de filtration d’eau Arctic Pure Nettoyant et désinfectant ManitowocListe de vérification Section Service clientèleService clientèle Section Garantie Limitée Période DE Cette Garantie Limitée Service clientèle Section Section Service clientèle Manitowoc

RF specifications

Manitowoc Ice RF is a leading series in the ice-making industry, renowned for its innovative technologies and commitment to efficiency. Designed to meet the high demands of commercial food service operations, the RF model features a range of cutting-edge attributes that set it apart from competitors.

One of the main features of Manitowoc Ice RF is its advanced refrigeration system. The machine employs an Adaptive Harvest Control technology that ensures consistent ice quality by continually monitoring the ice-making process and adjusting accordingly. This results in reliable production of clear, hard ice cubes without the usual inconsistencies found in other machines.

The Manitowoc Ice RF models are designed with energy efficiency in mind. They utilize high-efficiency compressors and optimized insulation methods, significantly reducing energy consumption compared to traditional ice machines. This not only contributes to cost savings for businesses but also aligns with environmentally conscious practices, helping to reduce the overall carbon footprint.

Another notable characteristic of the RF series is its streamlined design, which allows for easy installation and maintenance. The machines are compact, making them ideal for establishments with limited space. The removable panels and accessible components simplify routine cleaning and servicing, ensuring the unit operates at peak performance and extends its life cycle.

Food safety is another focus of the Manitowoc Ice RF series. The machines incorporate an internal, easy-to-clean design that minimizes the risk of contamination. The anti-microbial protection on key surfaces helps prevent the growth of harmful bacteria, ensuring that the ice produced is safe for consumption.

In addition to its robust construction and technology, Manitowoc Ice RF offers various production capacities, catering to different business needs. Whether in a bustling restaurant, a hotel, or a convenience store, there is a model that fits the required ice production volume.

Overall, the Manitowoc Ice RF series combines state-of-the-art technology, energy efficiency, and ease of use to provide an exceptional ice-making solution for commercial establishments. Its commitment to quality and innovation makes it a preferred choice for businesses aiming to enhance their food service operations while maintaining high standards of safety and efficiency.