A and B Components
Changing Materials
•When changing materials, flush the equipment mul- tiple times to ensure it is thoroughly clean.
•Always clean the fluid inlet strainers after flushing.
•Check with your material manufacturer for chemical compatibility.
•Most materials use ISO on the A side, but some use ISO on the B side.
•Epoxies often have amines on the B (hardener) side. Polyureas often have amines on the B (resin) side.
A and B Components
IMPORTANT!
Material suppliers can vary in how they refer to plural component materials.
Be aware that when standing in front of the manifold on proportioner:
•Component A (Red) is on the left side.
•Component B (Blue) is on the right side.
For all machines:
•The A (Red) side is intended for ISO, hardeners, and catalysts.
•If one of the materials being used is
•The B (blue) side is intended for polyols, resins, and bases.
NOTE: For ratios higher than 1:1, the higher volume is typically the B (Blue) side.
3A0237L | 15 |