Graco 3A0237L 15F144 Hose Wire Jumper, Part Description Qty, Connect 258758

Parts

15F144 Hose Wire Jumper

Use the 15F144 Hose Wire Jumper to heat only the major volume hose, in a wide ratio system.

To build one complete 50 ft single side heated hose bun- dle, order the following parts:

1.Wrap hose wire jumper (100) around resin hose (101) in a spiral fashion.

2.Connect resin hose wire (101a) to other side of Power-Lock™connector (100a); see page 16.

3.Wrap FTS cable (102) around resin hose (101) in a spiral fashion.

Ref.	Part	Description	Qty	4.	Twist hoses (101 and 105) together to provide strain
100	15F144	JUMPER, hose wire; includes	1
					relief.
		two 117789 electrical connec-
		tors; 50 ft (15.2 m) long		5.	Repeat steps 1-4 for each length of hose (101).
101	chart 2,	HOSE, resin, heated; 50 ft (15.2	1
					Connect hoses, electrical connectors, and cables;
	page 36	m) minimum
					see , page 16.
102	15B296	CABLE, FTS	1
103	15C517	HARNESS, hose jumper	1	6.	Install one -Lock connector (100a) between wires;
104	261670	FLUID TEMPERATURE	1		see page 17.
		SENSOR		7.	Connect 258758, page 20.
105	pur-	HOSE, hardener, unheated; 50	1
	chase	ft (15.2 m) minimum; customer		8.	Install whip hose and gun. Ensure that gun is
	locally	supplied			grounded.
106	pur-	CONNECTORS, fluid; as	as
	chase	required to complete assembly;	req’d	9.	Connect hoses to proportioner.
	locally	not shown
Install as follows:				10.	Insulate and protect hoses. See Protective Cover-
					ing, page 22.

Hoses (101 and 105) must be sized and pressure rated to meet the requirements of your system.

Do not operate heated hose (101) at more than 45 A. If hose is cold, turn current adjustment fully counter- clockwise before reheating hose.

Spray gun must be grounded.

105

	102
100	101a	FTS
		100a

100a 101 TI14739a

100

101a

36 3A0237L